Determine shear stress on the failure plane at failure tao

Assignment Help Civil Engineering
Reference no: EM13322593

A conventional consolidated drained (CD) triaxial test is conducted on sand. The cell pressure is 100 kPa, and the applied axial stress at failure is 200 kPa.
Required:

a. Plot the Mohr circles for both (1) initial and (2) failure stress conditions.

b. Determine Phi (assume c=0)

c. Determine (3) the shear stress on the failure plane at failure Tao,ff and find (4) the theoretical angle of the failure plane in the specimen.

d. Determine (5) the maximum shear stress at failure Tao,max and (6) the angle of the plane on which Tao,max acts; calculate (7) the available shear stress on the plane.

e. Calculate factor of safety (F.S.) on (8) the plane of Tao,max and (9) the failure plane.

Reference no: EM13322593

Questions Cloud

What is the reading of the spring scale : A 10 kilogram block of metal measuring 12cm by 10 cm by 10 cm is suspended from a scale and immersed in water. What is the reading of the spring scale
Determine the depth of cut or fill for the point : The station and elevation of the PVI is 8+17.36 and 76.85 ft. Assume that there will be stakes placed at the PVI, BVC, and EVC, the low (or high) point, and at all the 100-ft stations.
Find the force on either side where the board is supported : A 245 kg person lays on board that is supported only on the ends and that has a mass of 12.0 kg. what is the force on either side where the board is supported
An arrow is shot at an angle of ?=45° above the horizontal : An arrow is shot at an angle of θ=45° above the horizontal.
Determine shear stress on the failure plane at failure tao : A conventional consolidated drained (CD) triaxial test is conducted on sand. The cell pressure is 100 kPa, and the applied axial stress at failure is 200 kPa.
Declaring a child class : Note that you will be overriding three object methods in the Order class and at least one of those in the ShippedOrder class. In the ShippedOrder class you will also need to override the Quantity accessor/property. Don't forget about IComparable.
Explain solid cobalt hydroxide dissociates in water : Solid cobalt(II) hydroxide dissociates in water according to the following expression. Co(OH)2(s) Co2+(aq) + 2 OH-(aq) If 1.00 L of saturated Co(OH)2 solution is neutralized by 15.20 mL of 0.00150 M HCl
Calculate the mass of the air in the room : A physics lecture room has a volume of 251m^3. Calculate the mass of the air in the room
Estimate the source strength of the heater mg per hr : A convective kerosene heater is tested in a well-mixed chamber having an air exchange rate of 0.39 ach. After 1 hour of operation, the NO concentration reached 4.7 ppm (remember PV=nRT).

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the difference in total cost between the two options

Two remediation options are being considered for a contaminated land area formerly used for industrial operations. Option 1 involves removing all of the contaminated soil over a two-year period at a cost of 2.2$ million per year

  What is the equation to get volume of cut and volume of fill

what is the equation to get volume of cut and volume of fill if i used excel formulated , in construction methods.

  How to determine the efficiency of the pump

Water is pumped at a rate of 1.57 cfs from one large open tank into another through a 6 in diameter cast iron pipe 400 ft long. The water level in the second tank is 160 ft above the level of the first tank and the discharge end of the pipe is sub..

  How to determine the grade of the road of an object

A driver is travelling at 50 mi/h on a wet road. An object is spotted on the road 500 ft ahead and the driver is able to come to a complete stop just before hitting the object.

  Rocket velocity as a function of time

(a) Use differentiation to find a general expression for the rocket's velocity as a function of time, (b) When is the velocity zero?

  Estimate the force on the chimney at the bottom of chimney

The wind blows horizontally in a direction which is parallel to one of the diagonals of the cross section. Careful measurement shows that, at height y from the ground, the magnitude of the wind velocity is given

  Calculate primary consolidation settlement for the ch layer

Calculate the primary consolidation settlement for the CH layer, assuming that it is normally consolidated with a water content of 70% and a compression index of 0.25.

  What is the capacity of the runway in aircraft per hour

A runway used for landing only is used by two types of aircraft, one with an airspeed of 120 knots (nautical miles/hr) and the other with an airspeed of 150 knots. The length of common approach path is 6 nautical miles.

  Determine temperature of the combined wastewater and stream

A municipal WWTP discharges 22.5 MGD of secondary effluent containing 45 mg/L of ultimate BOD at 26.7 oC with 1.3 mg/L of dissolved oxygen. The stream flow is 237 ft3/s at a velocity of 2.1 ft/s and an average depth of 7 ft.

  Determine the mass flow rate of nitrogen through compressor

Nitrogen is compressed from 80 kPa and 27?C to 480 kPa by a 10-kW compressor. Determine the mass flow rate of nitrogen through the compressor, assuming the compression process to be (a) isentropic

  F-m ration for conventional activated sludge plant

A 4000-m 3 /day conventional activated sludge plant has an influent with a BOD5 of 190 mg/L and SS of 225 mg/L. What population would this plant serve?

  Determine what would be the co concentration in the box

A simple way to model air pollution over a city is with a box model that assumes complete mixing and limited capability for the pollution to disperse horizontally or vertically except in the direction of the prevailing winds

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd