Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Determine how many buses needed to provide service on the following route with the indicated characteristics: -Route length: 16 miles (one way) -Headway: 15 minutes -Average number of stops made during run, one direction: 22 -Terminal time at each end: 10 minutes -Average route speed: 38 miles per hour -Acceleration/Deceleration time: 15 seconds per stop -Dwell time (average): 35 seconds
a) How many buses needed?
b) How much of a reduction in terminal time would be required to reduce the number of required buses by one?
THe upper end of the spring is welded to the lunger and the lower end is welded to the base plate. If the plunger is lifted 1.5" above equilibrium and released from rest, calculate its velocity as it strikes A.
What is the chemical name of the first hazardous air pollutant under Title III regarding the Clean Air Act
An engineering student is driving on a level roadway and sees a construction sign 180 m ahead in the middle of the roadway. The student strikes the sign at 56 kph. If the student was traveling at 90 kph when the sign was first spotted, what was th..
at one point on the highway, a 720 ft equal-tangent crest vertical curve exists. measurements show that at 3+40 stations from the PVC, the vertical curve offset is 3.5 ft. assess the adequacy of this existing curve in light of the reconstruction d..
Geometric design and construction of a new two-lane two-way road has been recently completed and now it is time for design pavement near Ballarat, Victoria.
Block D sits freely on the homogeneous bar and experiences a gravitational force of 50N. Homogeneous bar AB experiences a gravitational force of 25 N. What is the force between the bar and block D?
A gas has a volume of 2.0 liters, a pressure of 1.2 atm, and a temperature of 30 degrees Celsius is heated to 60 degrees Celsius and compressed to a volume of 1.5 liters. What is the new pressure
The heat exchanger consists of 12 m of copper tubing that is 2 cm in diameter with 19 return bends. The flow rate is 3 x 10-4 m3/s. Water enters at 20 C and exits at 80 C. The elevation difference between the entrance and the exit is 0.8 m.
a gate having cross section shown in fig closes an opening 5 ft and 4 ft high in a water reservoir. The gate weighs 400lb and its center of gravity is 1 ft to the left of AC and 2 ft above BC. Determine the horizontal reaction that is developed on..
Assuming uniformly decelerated motion, determine the velocity and acceleration of point C of the belt, (a) immediately before the power is turned off. (b) 9 s later.
An open top tank contains a layer of SAE 30 oil 0.5 m thick, a layer of water 0.7 m thick, and a layer of mercury 0.3 m thick. Calculate the pressure, and the piezometric head at the free surface, at both interfaces, and at the tank bottom.
The motion occurs in the horizontal x-y plane. Determine the velocity V2 of the particle at the end of the 3-s interval.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd