Determine downstream depth into gradual contraction section

Assignment Help Civil Engineering
Reference no: EM13313848

Water in a rectangular channel flows into a gradual contraction section. If the flowrate is Q = 25 ft^3/s and the upstream depth is 2 ft, determine the downstream depth. Sketch the specific energy diagram and indicate its important characteristics. Note that the specific discharges are different.

Reference no: EM13313848

Questions Cloud

What is the average density of the actual solids contained : a 50cm^3 sample of dry soil from an aquifer weighs 100g. when it is poured into a graduated cylinder, it displaces 35cm^3 of water. What is the porosity of the soil. What is the average density of the actual solids contained in the soil
Determine the new depth if the flow rate remains the same : During the following day the sun melts the ice cover. Determine the new depth if the flow rate remains the same and the surface roughness of the ice is essentially the same as that for the bottom and sides of the river.
What will be its rate of rotation : A spherical ball of material is rotating about its center at 35 rad/s. It has a mass of 2.0 kg and a radius of 0.11 m. what will be its rate of rotation
Discuss the leader specific traits : Discuss the leader's specific traits
Determine downstream depth into gradual contraction section : If the flowrate is Q = 25 ft^3/s and the upstream depth is 2 ft, determine the downstream depth. Sketch the specific energy diagram and indicate its important characteristics. Note that the specific discharges are different.
Find the moment of inertia of this system : A 6.00 kg mass is located at (2.00m, 2.00m, 2.00m) and a 5.00 kg mass is located at (-1.00m, 3.00m, -2.00 m). find the moment of inertia of this system
Chances of errors are less in continuous flow manufacturing : The technology is being regarded as an integral step in lean operations for pharmaceutical manufacturing, due to efficient waste management, lesser space utilization, higher efficiency of process and better quality of products. What is your opinio..
Verify that there are no outliers in the sample data : The measurements of the nominal shear strength (in kN) for a sample of 15 prestressed concrete beams are as follows: 580 400 428 825 850 875 920 550 575 750 636 360 590 735 950
Explain the final temperature once thermal equilibrium : what is the final temperature once thermal equilibrium is reached. c) how much ice remains once thermal equilibrium is reached.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find what is the pressure on the soil if theta is 45 degrees

A pipe is to be installed under the ground on a bed of aggregate 6 in. thick. The entire weight on the aggregate from pipe and soil above the pipe is 1800 lbs. per linear foot of pipe. What is the pressure on the soil if theta is 45 degrees

  Determine what volume of naocl will be needed

An electric power plant consumes 2.5 million gallons per day of cooling water. To control bacterial growth (slime), 2.0 mg/L of chlorine (measured as Cl2) is injected into the make-up water fed to the system.

  Estimate length of pipeline required for the friction losses

Water leaves a reservoir at 0.05 m^3/s through a 200-mm riveted steel pipeline that protrudes into the reservoir and then immediately turns a 90º bend with a local (minor) loss coefficient equal to 0.3.

  What is the soils unit weight when the degree of saturation

A dry quartz sand has a unit weight of 100 pcf. What is the soil's unit weight when the degree of saturation is 75% if Gs = 2.66

  Determine the corresponding value

Link ABrotates through a limited range of angle β, and its end Acauses the slotted link ACto rotate also. For the instant represented where β= 60 and = 0.6 rad/sconstant, determine the corresponding value of r r'.

  Determine what is the departure rate at a parking lot

The arrival rate at a parking lot is 6 veh/ min. Vehicles start arriving at 6: 00 P. M., and when the queue reaches 36 vehicles, service begins. If company policy is that total vehicle delay should be equal to 500 veh-min

  Determine the common velocity just after the collision

The bus B has a weight of 15,000 lb and is traveling to the right at 5ft/s. Meanwhile a 3,000 lb car A is traveling at 4ft/s to the left. If the vehicles crash head-on and become entagled, determine their common velocity just after the collision.

  Determine annual volume of lanfill comsumed in meter

A MSW landfill is being designed to handle solid waste generated by Binford at a rate of 50 Mg/d. It is expected that the waste will be delivered by compactor truck on a 5d/week basis.

  Calculate the maximum mounding height from the canal

If the hydraulic head in the canal is 100 ft and in the drainage ditch it is 80 ft calculate the maximum mounding height and the mounding distance from the canal that will occur if the farmer irrigates at a rate of 2 acre-ft/acre/year.

  What is highest possible final grade in nighttime conditions

An equal-tangent sag curve has its PVI at station 10+00 and elevation at 138 ft. Directly above the PVI the bottom of an overpass structure is at elevation 162 ft. The PVC is at station 4+00. If the initial grade is -4.0%

  What is the mach number of the flow around the aircraft

A jet aircraft flies at a speed of 600 mph at an altitude of 40,000 ft. The atmosphere is the standard atmosphere. (1) What is the air pressure outside the aircraft (2) What is the Mach number of the flow around the aircraft

  Determine the speed of the car when time t is given

The 1.2-Mg mine car is being pulled by winch M mounted on the car. If the winch generates a constant power output of 30 kW, and the car starts from rest, determine the speed of the car when t = 5s.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd