Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
determine critical depth in a circular pipe of 36 inches diameter and roughness coefficient of 0.015 The flow rate is 15 cfs , So = 0.002
The block has a mass of 150 kg and rests on a surface for which the coefficients of static and kinetic friction are 0.5 and 0.4, respectively. If a force F = (60t^2) N, where t is in seconds, is applied to the cable, determine the power developed ..
the rigid bar abcd is supported by a pin at B and restrained by identical steel bars at C and D, each of area 250mm^2. if the temperature is increased by 80C, determine the force P that will cause the bar at c to be stress-free.
Three-ply asphalt felt and gravel roof over 2in of insulation board is supported by 18in deep precast reinforced concrete beams with 3ft wide flanges. If insulation weights 3lb/ft 2 and the asphalt roofing weights 5.5lb/ft2, determine the total dea..
in inclined circular gate with water on one side shown in the figure. determine the total resultant force acting on the gate and the total location of center pressure.
The engine of an automobile supplies 180 hp at 2500 rpm to the drive shaft. If the maximum shearing stress in the drive shaft must be limited to 6 ksi, determine the minimum diameter required (in inches) for a solid drive shaft.
The "Shape Factor" of a cross-section of a beam is defined as the fully plastic strength divided by the force or moment causing first yield. Thus the Shape Factor for bending is Mp/My and similarly for shear, is Vp/Vy.
The three blocks shown move move with constant velocities. Find the velocity of each block, knowing that the relative velocity of A with respect to C is 300 mm/s upward and that the relative velocity of B with respect to A is 200 mm/s downward.
Suppose the summer daily demand for water use in Phoenix is normally distributed with a mean of 310 million gallons/day and a standard deviation of 45 million gallons/day. Also suppose the city has reservoirs whose combined storage is 350 million ..
What is the force of the water on a spillway whose upstream depth is 1.2m and whose downstream depth is 0.2m. The width of the spillway is 3m.
How many kg/day of NaOH must be added to neutralize a waste stream generated by an industry producing 90.8 million g/day of sulfuric acid, if 0.1% of the sulfuric acid produced is lost to wastewater The wastewater flow is 750,000 L/day
A u-tube manometer is used to measure the pressure of a vessel under vacuum. Assume the manometer is open to atmospheric pressure (101.325 kPa) and the density of the fluid in the manometer is 12 g/cm3.
Determine the axial and hoop stresses at the lower end of the vessel. A standpipe 12 ft in diameter and 50 ft tall is being con- structed for use as a storage tank for water with a specific weight of 62.4 lb/ft3. The wall thickness of the vessel is..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd