Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A civil engineer used a 30-m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20 m long. The difference in elevation between the initial and the end point was found to be 1.25 m. The 30-m tape is of standard length at a temperature of 10ºC and a pull of 5 kg. During measurement the temperature reading was 15ºC and the tape was supported at both ends with an applied pull of 7.5 kg. The cross-sectional area of the tape is 0.065 cm2 and E = 2.0 x 106 kg/cm2. The tape weighs 0.075 kg/m and has a linear expansion is 0.0000116 / ºC. Apply corrections for temperature, pull, and sag to determine the correct horizontal distance considering a gentle slope.
what is the distiniction b/n point and non point sources of water pollution and thier varation with surface and ground water?
A fully loaded, ocean going container ship is just stable about its longitudinal axis (roll). The ship has a total weight of 155,000 tons, length = 1,600 feet and a beam = 150 feet (assume that it is the shape of a rectangular box). Calculate the ..
a tank contains 650 cubic feet of water.the water will be applied on 7 acres of land. What would be the the depth of water im millimeters on the land assuming that there are no losses
Find the mass of air in a closed chamber measuring 35 ft by 20 ft by 10 ft, when the pressure is 17 lb/in^2 and the temperature is 75°F, assuming air to be an ideal gas
An ocean outfall diffuser that discharges treated wastewater into the Pacific Ocean is 500m from a public beach. The wastewater contains 105 coliform bacteria per milliliter. The wastewater discharge flow rate is 0.3 m3/s.
A tank contains 0.05 m^3 of nitrogen gas at -21 C and 10 MPa. Determine the mass of nitrogen, in kg, using: a) the ideal gas model b) data from the compressibility chart Comment on the applicability of using the ideal gas model for nitrogen at thi..
the motorcycle is traveling at 1 m/s when it is at A at the bottom of the ramp. If the speed is then increased at v=0.1 m/s^2, determine its speed and acceleration at the instant t=5s
Determine the required dimensions. The inside diameter is to be two- thirds of the outside diameter. The allowable shearing stress is 70 MPa, and the angle of twist is not to exceed 4 degree in 3 m of the shaft.
During a snowstorm the fluoride feeder in North Bend runs out of feeder solution. The rapid mix tank is connected to a 5-km long distribution pipe. The flow rate into the rapid mix tank is 0.44m^3/sec, and the volume of the tank is 2.50 m^3.
A four-lane freeway (two lanes in each direction) is on mountainous terrain with 11-ft lanes, a 5-ft right-side shoulder, interchange spacing of one every 10 miles, and a 60-mi/h base free-flow speed.
The engine of an automobile supplies 180 hp at 2500 rpm to the drive shaft. If the maximum shearing stress in the drive shaft must be limited to 6 ksi, determine the minimum diameter required (in inches) for a solid drive shaft.
A 300 N force is applied at A. Determine (a) the moment of the 300 N force about D, (b) the magnitude and sense of the horizontal force applied at C that creates the same moment about D,
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd