Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A hydraulic transition 100 ft long is used to connect two rectangular channels, 12ft and 6ft wide. The design discharge is 500 cfs, mannining coefficient=.013 and the slopes of the channels are both .0009. Determine the change in the bottom elevation and the water surface if the energy loss is 1.5ft.
A cubic shape tank has the dimensions of 10 m by 10 m by 20 m tall. Calculate the volume of he tank in gallons
What is the concentration of tracer in the reactor 1 h after tracer addition is terminated? The reactor had an initial concentration of tracer of 1.0 mg/L when tracer addition commenced.
Determine the maximum service load W (kips) at the mid-height of the beam-column shown in the accompanying figure 2.1. Assume the member is hinged with respect to bending in both x and y directions at the top and bottom.
assume the drop has the shape of a hemisphere just before seperating. find an expression for the diameter, D, of the droplet, in terms of the specific weight and surface tension, assuming the contact angle just before seperating is zero.
4 in diameter pipeline 200ft long discharges water from nozzle with 2 in diameter jet at an elevation which is 100ft below the water level of supply reservoir. find flow rate through pipe
The bolts have a mean diameter of 1.000 cm, normally distributed with standard deviation of 0.010 cm. The holes have a mean diameter of 1.030 cm, normally distributed with standard deviation of 0.015 cm.
A turbine operates at steady state with steam flowing through it at a rate of 36 kg/min. The steam enters the turbine at a temperature of 600C and a pressure of 8 MPa and exits at a pressure 90% lower with a quality of 70%.
What is the TCE concentration in ppm if the tank is held at (a) 4 degrees C and (b) 35 degrees C (c) What is the TCE concentration in ppm if the tank is filled with hexane instead of water
At a certain location along the span, a reinforce concrete beam section with d=14 in. and b=10 in. is subject to a design shear of Vu=50k. Using No.4 stirrups, compute the required stirrup spacing at the given location. assume F'c=3 ksi and Fy=40 ..
A steel pipe carries an industrial oil under pressure. The steel pipe inside diameter is 36 in, the pressure head on the fluid is 383.0 ft. A)- Find the internal fluid pressure in psi
it was observed that the quantity of the water flowing through the sand layer into the collection ditch is 250 m^3/day. What is the hydraulic conductivity of the sand (k)
How does the engineering classification of soils differ from he engineering classification of rocks
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd