Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A lightweight rotating shaft for a pump on the national aerospace plane is to be designed to support a cyclical load of 15,000 pounds during service. The maximum stress is the same in both tension and compression. The endurance limits or fatigue strengths for several candidate materials are shown below. Design the shaft, including an appropriate material, and justify your solution.
A two-stage trickling filter plant treats 291.7 m3/h of municipal wastewater that has a BOD5 of 200 mg/L. The two filters have equal dimensions (depth = 1.68 m; diameter = 21.3 m), and each has a recycle ratio of 1.0
what is the standard size of Pcc specimens to be tested for compressive strength? if a smaller size is used, which size is expected to provide higher compressive strength close to that of an actual concrete structure?
The magnetic declination of 1986 was 5 degrees 15 minutes. The magnetic bearing of a line was N 89 degrees 49 minutes W. At todays present the magnetic bearing of a line is S 88 degrees 20 minutes W.
A flow of 28 m3s-1 occurs in an earth-lined canal having a base width of 3 m, side slopes of 1(vertical) to 2 (horizontal) and the Manning’s n value of 0.022. Calculate the critical depth and critical slope
The overpass structure is to be level, centered 26 feet above the railroad, and 180 feet long. How much existing highway (in feet) must be reconstructed to provide appropriate vertical alignment
Draw a graph showing the effluent concentration as a function of time for : a. Zero order CMFR and PFR with the same influent concentration and reaction rate. b. First order CMFR and PFR with the same influent concentration and reaction rate.
A divided multilane highway in a recreational area (fp = 0.90) has four lanes (two lanes in each direction) and is on rolling terrain. The highway has 10-ft lanes with a 6-ft right-side shoulder and a 3-fl left-side shoulder.
The two shafts are made of A-36 steel. Each has a diameter of 25 mm and they are connected using the gears fixed to their ends. Their other ends are attached to fixed supports at A and B.
The uniform load has a mass of 450 and is lifted using a uniform 35- strongback beam and four ropes. Determine the Tension in the ropes Determine the force that must be applied at A.
After injecting 50 MMSCF (14.7 psia and 60 oF), the pressure increase from 2500 to 3500 psia. Deviation factors for the gas are 0.90 at 3500 and 0.80 at 2500 psia and the bottom-hole temperature is 160 oF. What is the cubic feet of gas storage spa..
Water enters the lock of a ship canal through 180 ports, each port having a 2 ft by 2 ft cross section. The lock is 900 ft long and 105 ft wide. The lock is designed so that the water surface in it will rise at a maximum rate of 6 ft/min.
Two 15-m high rotors 3 m in diameter are used to propel a ship. Estimate the total longitudinal force exerted upon the rotors when the relative wind velocity is 25 knots, the angular velocity of the rotors is 220 revolutions per minute and the win..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd