Design the beam in us customary units using f

Assignment Help Civil Engineering
Reference no: EM13319438

A beam must carry a total factored bending moment of 1062kN-m. It has a maximum beam effective depth of 25in. Design the beam in US customary units using f'c=4ksi and fy=413.4MPa. If necessary use d'=2.5in. Assume an exterior exposure according to ACI 318 and b=15in.

Reference no: EM13319438

Questions Cloud

Compute the ph at the points in the titration : Calculate the pH at the points in the titration of 40.00 mL of 0.425 M NH3 for the reaction below. NH3(aq) + HNO3? NH4+(aq) + NO3?(aq) For NH3, Kb = 1.8x10-5. Enter your answer with 2 decimal places. Enter scientific notation as 1.23E4.
Determine the tension in each of the cables at a time : A long trough is supported by a hinge along its lower edge and a series of horizontal cables attached to its upper edge. Determine the tension in each of the cables, at a time when the trough is full of water.
With what minimum speed must he drive off horizontal ramp : A stunt driver wants to make his car jump over 8 cars parked side by side below a horizontal ramp as seen in the figure below. With what minimum speed must he drive off the horizontal ramp to just barely make it across
Define what is the ph at the equivalence point : What is the pH at the equivalence point when when 40.0 mL of 0.183 mol/L HC7H5O2(aq) is titrated with 0.131 mol/L NaOH(aq)? Assume the temperature is 25oC
Design the beam in us customary units using f : Design the beam in US customary units using f'c=4ksi and fy=413.4MPa. If necessary use d'=2.5in. Assume an exterior exposure according to ACI 318 and b=15in.
Explain with two significant digits : For a solution that is 0.282 M NH3 and 0.117 M NH4NO3, calculate the following. For NH3, Kb is 1.8x10-5. Enter [OH?] and [H3O+] with two significant digits. Enter scientific notation as 1.23E4.
Calculate head supplied by the pump for the system : Water from a lower reservoir (water surface elevation) 500 m is pumping to the upper reservoir (water surface elevation 600 m) through a 5000 m long straight pipe with 0.5 m diameter.
The firm is proposing to buy a new plant which can generate : The firm is proposing to buy a new plant which can generate additional annual profit of Rs. 10,000. The fixed costs of new plant is expected to Rs. 4000. The new plant will increase the sales volume by Rs. 40,000. It can be assumed that the ratio bet..
Explain what is the final ph of the solution : What is the final pH of the solution when 15.0 mL of 0.121 mol/L NaOH(aq) and 35.0 mL of 0.181 mol/L HNO2(aq) are mixed? Assume the temperature is 25oC.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What would the diameter corresponding to percent removal be

a standard reverse-flow cyclone with a length of 5cm has a cut diameter of 250 microns. at a flow rate of 10^-7 m^3/s, what would the diameter corresponding to 90% removal be

  Determine the tradeoff between the cost and the energy head

Two materials (wrought iron, ks = 0.046 mm, and galvanized iron, ks = 0.15 mm) are being considered for a new pipeline. The expected discharge is 0.15 m3/s. Both the head loss and cost are sought for.

  What amount of water use is exceeded with the probability

Suppose the summer daily demand for water use in Phoenix is normally distributed with a mean of 310 million gallons/day and a standard deviation of 45 million gallons/day. Also suppose the city has reservoirs whose combined storage is 350 million ..

  Determine the value of trelease and acceleration of boxes

Knowing that as a box B is released, the preceding box A has slid 6 meters down the slope and that 1 second later they are 10 meters apart, determine the following: (a) The value of trelease (b) The acceleration of the boxes.

  Calculate rate at which entropies of 2 reservoirs change

A completely reversible air conditioner provides 21,000Btu/h of cooling for a space maintained at 81degF while rejecting heat to the environmental air at 91degF.

  Determine the magnitude of the average force acting

Determine the magnitude of the average force acting on a highway bumper when a 5000-lb car traveling at 60 mph crashes against it. The time interval during which the car is brought to rest is 0.3 s.

  Calculate the specific energy when depth of flow

A rectangular channel of 20 f t width and having n = 0.017 carries flow of 800 f t^3/s. Calculate (a) critical depth (b) the minimum speci c energy (c) the speci c energy when depth of flow is 7 f t.

  How many days will contractor require to complete the work

A contractor has both a 3-cy and a 5-cy shovel in the equipment fleet. Select the minimum-size shovel that will excavate 400,000 bcy of common earth in a minimum of 130 working days of 8 hr each.

  Fraction of the herbicide

The herbicide 2,4,D, is applied to a golf course at a rate of 1.2 kg/ha. The organic matter content of the soil is 1%, bulk density is 1.3 g/cm3, and water content is 0.3. a) What fraction of the herbicide is adsorbed, and what fraction is dissolve..

  Thermo-gravimetry of calcium oxalate

Evaluate the percent mass loss for each of the three thermal events indicated on the attached TGA trace

  How fast will it be going when it hits the ground

How fast will it be going when it hits the ground?

  Calculate the factor of safety and deformation

A 1 cm diameter, 0.4 m long steel rod is to be used in an application where it will be subjected to an axial tensile force of 15kN. The factor of safety based on yield stress must be at least 1.5, and the axial deformation must not exceed 2 cm.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd