Design half-wave rectifier power supply to deliver avg volt

Assignment Help Electrical Engineering

Reference no: EM13294998

Design a half-wave rectifier power supply tto deliver an average voltage of 9V with a peak to peak ripple of 2V to a load. The average load current is 100mA. Assume that ideal diodes and 60Hz. ac voltage sources of any amplitudes needed are available. Draw the circuit diagram for your design. Specify the values of the compnents used.

Reference no: EM13294998

Questions Cloud

Determine wind speed and direction of an airplane : Given and airplane whose velocity relative to air (airspeed)is 120 km/hr (heading), the direction of the velocity vector is 70degrees east of north. Velocity relative to ground(groundspeed) is 110 km/hr (course)

Find resistive force does the wood exert on the bullet : A rifle with a barrel length of 65 cm fires a 9 g bullet with a horizontal speed of 380 m/s. find resistive force does the wood exert on the bullet

What is the future value of this cash flow stream : Now consider the uneven cash flow stream stemming from the lease agreement given in the case.

Importance of implementing a quality improvement process : What is the importance of implementing a quality improvement process to reduce the incidence of the safety issue and what would be a method of application of the quality process to the safety issue?

Design half-wave rectifier power supply to deliver avg volt : Design a half-wave rectifier power supply to deliver an average voltage of 9V with a peak to peak ripple of 2V to a load. The average load current is 100mA. Assume that ideal diodes and 60Hz. ac voltage sources of any amplitudes needed are avail..

How to determine delta h for the reaction : Using only your answer to a, and the following information: Delta H = -283.0 kJ/mol for the reaction: CO(g) +1/2 O2 (g) --> CO2 (g), determine delta H for the reaction: 4CO (g) + 2NO2 (g) --> 4CO2(g) + N2 (g).

What is the skateboards acceleration down the ramp : a skateboard with mass M rolls down a ramp, starting from rest. It takes a time T to roll a distance L along the ramp

Determine the heat transferred per pound mass : For the process where wk(closedsystem)=778 ft*lbf/lbm and ?u= 0.75 Btu/lbm, determine the heat transferred per pound mass

Design a logic network to control the lights of the doors : A long hallway has three doors, one at each end and one in the middle. A switch is located at each door to operate the incandescent lights along the hallway. Label the switches A,B, and C. Design a logic network to control the lights.

User Account

All Pages