Design an earthen channel section into sandy soil

Assignment Help Civil Engineering
Reference no: EM13298319

An earthen channel will be excavated into sandy soil for which Vmax = 4.0 ft/sec, n = 0.022, and the recommended m = 3. The channel will have a bottom slope of 0.0011 and accommodate a design flow of 303 cfs. Design (size) the channel section.

Reference no: EM13298319

Questions Cloud

What emf is induced across the wings : a metal airplane flies horizontally at 200. m/s where the Earth's magnetic fiels is vertical and is 45.0uT. If the wingspan is 25.0 meters. what emf is induced across the wings
Calculate the ph of a 1-l solution containing sodium acetate : Calculate the pH of a 1-L solution containing 0.01 M sodium acetate after the addition of 3 mL 0.5 M H2SO4
Determine the manning coefficient of channel roughness : A discharge of 2,200 ft^3/sec flows in a trapezoidal channel at a normal depth of 8.0 ft. The channel has a slope of 0.01, a 12-ft bottom width, and side slopes of 1:1 (H:V). Determine the manning coefficient of channel roughness
Which stock would you consider to be riskier : You have estimated the following probability distributions of expected future returns for Stocks X and Y.
Design an earthen channel section into sandy soil : An earthen channel will be excavated into sandy soil for which Vmax = 4.0 ft/sec, n = 0.022, and the recommended m = 3. The channel will have a bottom slope of 0.0011 and accommodate a design flow of 303 cfs. Design (size) the channel section.
Calculate the annual rate of depreciation : In two year you need to earn 3000$ if you get an interest rate of 15.75% compound annually, how much do you need to invest now
Design lined trapezoidal channel to carry on longitudinal : Design a lined trapezoidal channel to carry 20 m^3/sec on a longitudinal sloe of 0.0015. The lining of the channel is to be float-finished concrete (n=0.015). Consider (a) the best hydraulic section and (b) the section with side slopes 1.5:1 (H:V)
Calculate the net working capital at the end of 2005 : Lennox Furniture Company's 2005 balance sheet showed total current assets of $1,200,000. All of the current assets were required in operations, and its current liabilities consisted of $400,000 of accounts payable and $100,000 of accrued wages and..
Explain by using examples how an asset is being valued : SBS Corp is considering restructuring its capital to increase its value. The company is a power utility provider. What in your opinion is the best capital structure for the company?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the change in the bar thickness of axial load

At an axial load of 23 kN, a 40-mm-wide by 10-mm-thick polyimide polymer bar elongates 2.7 mm while the bar width contracts 0.17 mm. The bar is 240 mm long. At the 23-kN load, the stress in the polymer bar is less than its proportional limit.

  Calculate the effluent concentration from the reactor

You plan to use a tank of total volume V= 10 m3 to remove a contaminant at concentration Cin = 1 g/m3 from a waste stream with a flow rate of Q = 1 m3/h. The reaction is first order with a rate constant k1 = 0.5 h-1.

  Problem related to aerial photograph

The distance covered by an aerial photograph is determined by both the focal length of the camera and the tilt of the camera. Although the tilt is usually small, both archaeological and Canadian photographs often use larger tilts.

  Water system design

Determine the corresponding error in the computed discharge

  What is shear force exerted by oil on m long section of pipe

the flow profile is such that u=u(max)*(1-(r/R)^2) where u is the flow speed and r is the distance from the centre of the pipe in the radial direction. What is the shear stress on the pipe wall What is the shear force exerted by the oil on a 1m lo..

  Determine the mass ratio

Determine the mass ratio, For a vehicle in gravitationless space, determine the mass ratio necessary to boost the vehicle velocity by 1600 m/sec

  Scale of a spring balance problem

The scale of a spring balance reading from 0 to 235 N has a length of 13.0 cm. A fish hanging from the bottom of the spring oscillates....

  Determine the mass flowrate through boiler

The inlet of loe pressure turbine is 500Kpa and 500°C. Condenser operates at 10 Kpa. Determine the mass flowrate through boiler needed to produce 5000KW of power.

  Comparative analysis of the types of safeguards

Provide a comparative analysis of the types of safeguards would you suggest for the company's information system.

  Find what must be the composition in copper-nickel alloy

It is desirable to produce a copper-nickel alloy that has a minimum noncold-worked tensile strength of 390 Mpa and a ductility of at least 40% elongation. Is such an alloy possible If so, what must be its composition

  Compute the new unit weight and moisture content of soil

A sample of soil was compacted into a 945 ml.laboratory mold. The mass of the compacted soil was 1850 grams and its moisture content was 13.1%. Specific gravity of solids is 2.70, Compute the moist unit weight, dry unit weight, and degree of satu..

  Problem regarding helium balloons

To float a 160 pound man using helium balloons (assume 0.52 cubic feet per inflated balloon). How many balloons would it take? Assume density of air is 1.29 kg/cubic meter and the density of helium is 0.179 kg/cubic meter.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd