Design a two stage amplifier to meet the following specs

Assignment Help Electrical Engineering
Reference no: EM13383776

Design a two stage amplifier to meet the following specs: Undistorted output(at least 10Vp-p), Bandwith from 20Hz to 15kHz, AC coupled, stage to stage and to output, Overall voltage gain of 20dB, Use a 20(max)volt single sided power supply, output load will be 470 ohm?

Reference no: EM13383776

Questions Cloud

At ordinary body temperature 37 the solubility of in water : at ordinary body temperature 37 the solubility of in water in contact with air at ordinary atmospheric pressure 1.0
A chemist studying the properties of photo-nbsp graphic : a chemist studying the properties of photo-nbsp graphic emulsions needed to prepare 500 mlnbsp of 0.18 m agno3 aq. what
The vapor above a mixture of pentane and hexane at room : the vapor above a mixture of pentane and hexane at room temperature contains 35.5 pentane by mass. what is the mass
What will the volume of the sample become if 459 ml of an : what will the volume of the sample become if 459 ml of an ideal gas at 27 degrees of carbon and 1.05 atm is cooled to
Design a two stage amplifier to meet the following specs : design a two stage amplifier to meet the following specs undistorted outputat least 10vp-p bandwith from 20hz to
Pure liquid octane d 0709 gml is used as the fuel in a : pure liquid octane d 0.709 gml is used as the fuel in a test of a new automobile drive train. how much energy in kj is
You have 750 ml of a 250 m solution of na2cro4aq you also : you have 75.0 ml of a 2.50 m solution of na2cro4aq. you also have 125 ml of a 1.79 m solution of agno3aq. calculate the
Consider an ideal pn junction diode at t300k operating in : consider an ideal pn junction diode at t300k operating in the forwared bias region.nbspnbspcalculate the change in
You then add a volume of hcl exactly equal to frac12 the : suppose you accidently add too much naoh during the titration. you then add a volume of hcl exactly equal to frac12 the

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the density function py y in terms of p and t

Two statistically dependent random variables x1 and x2 are applied at the inputs to a threshold detector , the output from which is equal to the number of inputs that exceed the threshold T. Thus, y = 0, 1 or 2.

  Explain why the short-circuit method for determining

Explain why the short-circuit method for determining the Thevenin resistance of a circuit cannot be applied if the circuit does not contain any independent current or voltage sources.

  What is the principle behind cathode ray oscilloscope

What is the principle behind CRT(CATHODE RAY OSCILLOSCOPE), and How this method is simplified in LCD and LED. Is the same CRT principle used in LCD and LED Televisions. If no what is the principle used in LCD and LED Tvs.

  How will bjts current gain and breakdown voltage be changed

Consider a PNP BJT optimum designed for low voltage high current gain. (a)  Draw energy band diagram with proper labeling with VCB= -0.7V, VEB= 0.7V. Which mode is the BJT operated in (b)  Plot excess minority charges stored in each region with pro..

  What is the response of this system to the input x

A linear time-invariant system has a transfer function with a direct-current gain equal to 2 and a phase angle of 45°. What is the response of this system to the input x(t) = 4 cos(2t)

  Describe the steps in the keypad polling routine

Describe the steps in the keypad polling routine. Draw a flow chart for the keypad LCD software code. Discuss challenges experienced in developing the keypad LCD software code.

  Detailed explanation to op-amp

Detailed Explanation to Op-Amp, A certain op-amp has an open-loop voltage gain of 100,000 and a common mode gain of 0.2. Determine the CMRR in dB.

  Explain the difference between tdm and tdma.

Explain the difference between TDM and TDMA.

  What would be the battery voltage if it were being charged

The starter motor on a car draws 75-A starting current, which lowers the batery voltage from 12.6 to 9.1 V. What would be the battery voltage if it were being charged at 30 A.

  Design the simplest circuit that can accomplish the task

Suppose that we want to determine how many of the bits in a six-bit unsigned number are equal to 1 . Design the simplest circuit that can accomplish this task.

  How many spare tubes must the building custodian maintain

The time to failure of fluorescent lights in a large office building is exponentially distributed with a failure rate of 0.03125 hours. How many spare tubes must the building custodian maintain to have at least a 0.95 probability of replacing all..

  Find velocity of electrons that are moving only by diffusion

A general relationship for the current density carried by electrons of density n is J = qnv, where q is the electronic charge and v is the electron velocity due to drift and/or diffusion. (a) Find the velocity of electrons, v(x), that are moving on..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd