Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
For any precipitation-hardened alloy, like an al-cu alloy, the strengthening of the alloy depends on the size and number of the precipitates.
a) Calculate the cross-sectional area of a single 10-micron (10-5 m) diameter spherical precipitate.
b) Determine how many 1-micron spherical precipitates would be needed to have the same volume as the 10-micron precipitate.
c) Calculate the cross-sectional area of the single 10 micron precipitate and the many 1-micron precipitates.
d) Based on your calculations of cross-sectional area, which alloy would be more effective at stopping dislocations, those with a few 10-micron precipitates or those with many 1-micron precipitates? Which would have the higher strength? Which would have the higher ductility?
e) For an al-cu alloy of 4 atomic percent copper, 96 atomic % aluminium, estimate the density of the al-cu alloy compared to pure aluminium. is this a significant change that an airline company would care about?
Air flows steadily through a one-inlet, one-exit control volume. At the inlet, which has a flow area of 28 cm2, the air is at 600 kPa, 500 K, and has velocity of 30 m/s. At the exit, the pressure is 300 kPa, the temperature is 456.5 K, and the veloci..
SO3 has many uses including the production of sulfuric acid (H2SO4). A gas stream having the (molar) composition shown in the figure below is to be passed through a two-stage converter. The fractional conversion of SO2 to SO3 (per single pass) in the..
steam enters a urbine at 25 mpa 550c and exits at 5 mpa 325c at a flow rate of 70 kgs. determine the total power output
what force would be required to start a 250lb crate sliding across a cement floor which has a coefficient of static
You are required to include a short tabular summary with the following four elements for the two companies you select. For each of the companies, I would like you to provide approximately a 2-page summary with the following contents:
Derive at least four concept designs to satisfy the given specification - draw a central cross-section of the heat exchanger
an aircraft flying at 10000 feet uses a pitot-static tube to measure speed. the instrumentation on the aircraft
using ees or other software investigate the effect of reheat pressure on the performance of an ideal rankine cycle. the
The Reynolds number for a particular micro channel flow is found to be Re = 2. If all channel dimensions (length, width, and height) are reduced by a factor of 10, and the time required for a particle to traverse the length of the channel is invarian..
incoming air flow of 200 m3h at a temperature of 20oc and a humidity ratio of 0.012 kgvkga is mixed in a chamber with
a link containing points a amp b must assume the positions listed in the table for each problem. below graphically
a reversible heat pump cycle operates between hot and cold reservoirs at th 27degc and tc -3degc respectively.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd