Define heat is lost or absorbed by the calorimeter

Assignment Help Chemistry
Reference no: EM13664354

Suppose heat is lost or absorbed by the calorimeter itself would it give a higher or a lower value that the usual value or would this have remained unchanged?

Reference no: EM13664354

Questions Cloud

Explain are the melting behaviors of an ice cube : Explain are the melting behaviors of an ice cube, table sugar and table salt. Explain is there any structural information that could account for these behaviors
Presume that you have a solution of ascl3 with concentration : Presume that you have a solution of AsCl3 with a concentration of 1*10^-8 M. Presume the density of the solution is 1.00g/mL. The molar mass of AsCl3 is 181.28g. Convert this concentration to ppb on a mass to mass basis.
Compute the mass flow rate of the bottom product stream : Compute the mass flow rate of the bottom product stream as well as the mass fractions of the ethanol and water in the top product stream.
State a feed stream contains h2 co as well as a trace of ch4 : A feed stream contains H2 CO as well as a trace of CH4. Pure CH3OH is produced by income of a reactor, separator and recycle with purge to remove the non-reactive CH4.
Define heat is lost or absorbed by the calorimeter : Suppose heat is lost or absorbed by the calorimeter itself would it give a higher or a lower value that the usual value or would this have remained unchanged
Explain which piece of metal has highest final temperature : The molar heat ability of these three metals are 25.41 J/(mol•oC), 24.79 J/(mol•oC), and 25.95 J/(mol•oC), correspondingly. Explain which piece of metal has the highest final temperature
Define two weights are tied to the ends of a wire : Two weights are tied to the ends of a wire as well as the wire is placed on a block of ice with the weights hanging down over the sides. Ultimately the wire passes through the block, however the block remains intact.
Explain hydrogen extracted from citric acid intermediates : Explain Hydrogen extracted from citric acid intermediates are loaded onto electron carriers (NAD+, FAD). Where do these hydrogens end up eventually
Explain what is the primary function of co-enzyme a (coa) : Explain what is the primary function of co-enzyme A (CoA). Explain how does it work. Define what is the advantage of the thio-ester mechanism

Reviews

Write a Review

Chemistry Questions & Answers

  State the molecular weight of this compound was determined

50.0000 g of a compound showed that it contained 12.7520 g C,3.2105 g H, and 34.037 g S. The molecular weight of this compound was determined in a seperate expierment and found to be 94.19u.

  Explain sce stands for the saturated calomel electrode

Consider following cell. SCE stands for the saturated calomel reference electrode, which has a fixed potential of 0.244 volt. Pt|VOSO4 (0.0184 M), V2(SO4)3 (0.212 M), HClO4 (0.0100 M) || SCE Calculate the cell potential.

  Compute the molality h3po4 in the solution

Calculate the molality H3PO4 in the solution and Water is the solvent and the molarity of H3PO4 in the solution and the number of ml of the 85% H3PO4 that is required to make 800 ml of 2.00 M H3PO4?

  The activity of the antibiotic penicillin slowly decomposes

The activity of the antibiotic penicillin slowly decomposes when stored in a buffer at pH 7.0, 298K. The time dependence of the penicillin antibiotic activity

  Assuming the steady state approximation is valid for c what

consider the following mechanismab --gt cc --gt dassuming the steady state approximation is valid for c what is the

  Explain sodium carbonate reacts with silver nitrate

Sodium carbonate reacts with silver nitrate to produce sodium nitrate and solid silver carbonate

  Find alumimun metal for molten aluminum oxide

How much time is required to produce 200g of alumimun metal for molten aluminum oxide dissolved in cryolite, if you use a 12.0 amp current.

  Calculate the partial pressure (atm) of ch2o

The mass percent of a three component gas sample is 58.0% C2H4O2, 14.6% NH3 and 27.4% CH2O. Calculate the partial pressure (atm) of CH2O if the total pressure of the sample is 0.340 atm.

  Explain the pressure of the components on the left is p

Thus the pressure of the components on the left is P where as the pressure on the components on the right is P+Y. To make this clear I will write the chemical potentials as a function of the pressure (eg u1* (P) for the pure solvent on the left)

  Explain the dehydrogenation of ethanol

Acetaldehyde is produced by the dehydrogenation of ethanol according to the following reaction: C2H5OH CH3CHO + H2 An undesired side reaction occurs, which produces ethyl acetate: 2C2H5OH CH3COOC2H5 + 2H2 In a pilot plant, the conversion of ethano..

  Explain the equation is balanced

When the following equation is balanced, H2S + Fe(OH)3 ----> Fe2S3 + H2O the coefficient of H2S is

  How much heat energy, in kilojoules, is require

How much heat energy, in kilojoules, is required to convert 65.0g of ice at 18.0 degrees celcius to water at 25.0 degrees celcius.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd