Define ammonium chloride concentration

Assignment Help Chemistry
Reference no: EM13336610

Calculate the pH of a solution that has an ammonium chloride concentration of .05 M and a sodium acetate concentration of .045 M

Reference no: EM13336610

Questions Cloud

Explain the maximum age of a sample : What is the maximum age of a sample that can be measured by 14C dating if the error of measurement is 0.5%
How far upward from its initial position does the mercury : A U-shaped tube, open to the air on both ends, contains mercury. Water is poured into the left arm until the water column is 16.5cm deep.
Find the mass of the beam : Suppose we take a 1 m long uniform bar and support it at the 23 cm mark. Hanging a 0.36 kg mass on the short end of the beam results in the system being in balance
What is difference between published and hidden job market : What is the difference between the published job market and the hidden job market. What techniques would you usually use to access the published job market.
Define ammonium chloride concentration : Calculate the pH of a solution that has an ammonium chloride concentration of .05 M and a sodium acetate concentration of .045 M
Explain the solubility of zinc phosphate in pure water : Zinc phosphate (Zn3(PO4)2) has a solubility product constant Ksp = 9.0 x 10-33. What is the solubility of zinc phosphate in...pure water
Prepare a use case diagram for the case study : Case Study based on an Interview contained in a separate document (Please see the details in page 221 of your text book). Carefully read this case study. You are required to answer the following questions based on the Case Study.
Identify the descriptive statistics used : a. identify the descriptive statistics used,
Describe concentrated nitric acid : The concentration of a commercially available concentrated nitric acid is 70.0 percent by mass, or 15.9 M. In 100 grams of solution there are 1.11 mol of HNO3. Calculate the VOLUME of 100 grams of the solution

Reviews

Write a Review

Chemistry Questions & Answers

  Explain what does the difference indicate about your ability

Comment on the difference between the impure and crystallized sulfanilamide. What does the difference indicate about your ability to perform an effective crystallization

  What is the ratio of the rate constants for the reaction

What is the ratio of the rate constants for this reaction when the temperature is decreased from °C to °C?

  What volume of 420 ml of hydrogen occupy

what volume of 420 ml of hydrogen occupy if the temperature is raised from 0 C to 95 C?

  Calculate the mass of lycopene

(a)how do I calculate the concentration of the lycopene solution in the spectrophotometer cell before isomerization, given that the molar absorptivity of lycopene at 471 nm is 1.86 x 10^4. (b) Calculate the mass of lycopene in 3.0mL of the solutio..

  The al(oh)3 reacts with hcl(aq) the products are a chloride

The resulting solution required 13.73 mL of 0.176 mol L-1 NaOH(aq) to neutralize the excess, unreacted HCl. What was the percentage by mass of Mg(OH)2 in the original sample [Hint: When Mg(OH)2 or Al(OH)3 reacts with HCl(aq), the products are a ch..

  How did you deduce which spot corresponded to 2-naphthol

How did you deduce which spot corresponded to 2-naphthol on yourTLC plate that analyzed the reaction mixture at 10, 30, and 60 minutes. Did your TLC analysisindicate the presence of any 2-naphthol remaining atthe end of the 60-minute reaction time..

  State manic-depressive illness was analyzed for lithium

Serum taken from a patient being treated with lithium for manic-depressive illness was analyzed for lithium concentration. A reading of 332 units was obtained for the intensity of the 671 nm red emission line.

  State souble in diethyl ehter but insoluble in both ethanol

A given compound has the following solubility properties. At room temperature, it is souble in diethyl ehter but insoluble in both ethanol and water At high temperatures,

  Explain what would be the freezing point

What would be the freezing point for a 0.35m solution of sodium bromide in water? (Hoff factor = 1.75)

  Compute the rate of the redox reaction

we will measure the rate of the following redox reaction: 6I + BrO3 +6H -> 3I2 +Br + 3H2O rate = 1/3 delta[I2]/delta t after 219 seconds When the reactants are mixed it is found that the molarity of the I2 has increased from 0M to 1.0 x 10-4M . a)..

  How many kilojoules of heat is required

How many kilojoules of heat is required to completely covert 70.0 grams of water at 66.0° C to steam at 100°C?

  Define the ph of a solution prepared by diluting

Calculate the pH of a solution prepared by diluting 2.5 mL of 1M acetic acid up to a final volume of 100 mL (pka 4.76)

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd