Container is divided into two regions by a removable wall

Assignment Help Mechanical Engineering

Reference no: EM13709638

1. A rigid wall, insulated container is divided into two regions by a removable wall. One region contains 0.1 lbm of CO at 100F, while the other region contains 0.2 lbm of CO at 150?F. A stirrer is inserted into the container and when the wall between the two regions is removed the stirrer provides a shaft work input of 15 Btu. Determine the final temperature of the CO.

2. A balloon containing 0.5 kg of Refrigerant-12 is removed from the freezer at 100 kPa and -40?C and placed on the kitchen counter. Determine the heat transfer required to

(a) raise the R-12 temperature to its boiling point

(b) boil the liquid

You may assume that the kitchen pressure is 100 kPa.

3. Three of the processes that occur in the piston cylinder device of an internal combustion engine are:

Process 1: Constant pressure heat addition during which the volume doubles

Process 2: Isentropic expansion during which the volume increases 9 times

Process 3: Constant volume heat removal to a final pressure of 100 kPa

At the start of process 1 the engine contains 0.035 liters of air at 950 K and 5.7 MPa. For each of the three processes the air undergoes find the work and heat transfer in kJ. What is the total work and heat transfer for all three processes together?

Reference no: EM13709638

Questions Cloud

Power plant is being developed to operate irrigation system : A Rankine cycle power plant is being developed to operate an irrigation system. In this power plant solar energy will be used to boil a low boiling point fluid within glazed flat plate solar collectors. The working fluid that has been selected is the..

Determine the air exhaust velocity : Air is expanded isentropic ally in a horizontal nozzle from an initial pressure of 1.0 MPa, of a temperature of 800 K, to an exhaust pressure of 101 kPa. If the air enters the nozzle with a velocity of 100 m/s, determine the air exhaust velocity. Ass..

Oxygen flow being expelled from the cylinder generate : A high-pressure oxygen cylinder, typically found in most welding shops, accidentally is knocked over and the valve on top of the cylinder breaks off. This creates a hole with a radius of 14 mm. Prior to the accident, the internal pressure of the oxyg..

What is the mass flow rate through wind tunnel : An open wind tunnel with altitude of 1000m has Pin=89,876Pa, Ain=4m^2, T=281.7K, Vin=30m/s and the test section Aout=0.5m^2, Vtest=(X)m/s. R=287J/(Kg*K), density=1.1117kg/m^3 and dynamic viscosity=1.076E-05kg/m-s

Container is divided into two regions by a removable wall : A rigid wall, insulated container is divided into two regions by a removable wall. One region contains 0.1 lbm of CO at 100F, while the other region contains 0.2 lbm of CO at 150?F. A stirrer is inserted into the container and when the wall between t..

Compute the average density of a solid solution : Compute the average density of a solid solution which contains 10 kg of gold, Ag, and 90 kg of silver, Au. The density of pure gold is 19.32 g/cm3 and the density of pure silver is 10.49 g/cm3

Same surface concentration of carbon applied : You are considering two different diffusion processes involving Carbon into FCC iron. The first process is carried out at 900 oC for 3 hours and produces a carbon concentration of 0.20 wt% at a depth of 2 mm. At what depth would this concentration oc..

The airplane travels before hitting the slope : A paper airplane is thrown up a hill with slope theta = 16.26 deg during a rainstorm. The airplane has an initial speed of 10 ft/s and is fired at an angle of phi=32.52 deg from the horizontal. Rain accumulation on the wings results in a vertical acc..

Find the input-output equation using the p-operator : Find the input/output equation using the P-operator approach when x2 is the output.

User Account

All Pages