Compute the ph of 2.56x10-3 m monobasic base solution

Assignment Help Chemistry
Reference no: EM13677774

Compute the pH of 2.56x10-3 M monobasic base solution Presuming complete ionization

Reference no: EM13677774

Questions Cloud

Explain how do you find out maximum percent recovery : Explain how do you find out maximum percent recovery from recrystallization when you are given solubility at 60 C. and 0 C
Compute the molarity of the solution : An aqueous KNO3 solution is made using 77.8g of KNO3 diluted to a total solution volume of 2.04L. A) Compute the molarity of the solution. Presume a density of 1.05 g/mL for the solution.
Explain what is the enthalpy of the reaction : Presume the solution has the same specific heat as water 4.184 J/(g•°C) as well as that there's negligible heat loss to the surroundings. Explain how much heat was absorbed by the solution. Explain what is the enthalpy of the reaction
Explain how much n2 will be produced of a c6h12o6 solution : Explain how much N2 will be produced (L) when 6 liters of a C6H12O6 solution is degraded to CO2 as well as H2O? Explain the concentration of C6H12O6 solution is 200 mg/L.
Compute the ph of 2.56x10-3 m monobasic base solution : Compute the pH of 2.56x10-3 M monobasic base solution Presuming complete ionization
Explain how does the relative strength of the intermolecular : Explain how does the relative strength of the intermolecular forces between gas particles affect the gases deviation from ideal behavior
Explain how many grams of nitrogen monoxide can form : Explain how many grams of nitrogen monoxide can form by the reaction of 509g of ammonia and 979g of oxygen
Define what would be the molar volume : define what would be the molar volume at this pressure and at 25 degree Celsius based on (a) the ideal gas equation, (b) the van der Waals equation you will require to lool up the van der Waals constants for oxygen for this problem.
Explain what predictions about the primary structure : These questions need around a paragraph or two for the answer. For full rating, answer in such manner please. Explain what predictions can you make about the primary structure of an alpha-helical region of a protein that spans a biological membrane

Reviews

Write a Review

Chemistry Questions & Answers

  Calculate the ksp at this temperature

At 50 C, the solubility of silver chloride, AgCl is 5.2 x 10^-4 g/100mL. Calculate the Ksp at this temperature.

  Explain the most stable fragment peak in the mass spectrum

What m/z value would you predict for the most stable fragment peak in the mass spectrum of 4-ethylheptane ? a- 85 b-128 c-99 d-113 e- 127

  Predict the type of orbital from electron

For each of the subsequent ground state atoms, predict the type of orbital (1s, 2p, 3d, 4f, etc) from which an electron will need to be removed to form the +1 ions

  Define mass solution of silver nitrate should be used

A chemistry lab experiment requires 25.2 g of silver nitrate. How many grams of a 15.5% by mass solution of silver nitrate should be used.

  How many calories are required

How many calories are required to warm 15.0 g of water from 75 C to 100.0 C and convert it to steam at 100.0 C? The heat of vaporization of water is 540 cal/g.

  Explain the vapor pressure of pure water

The vapor pressure of pure water at 25°C is 23.77 mm Hg. What is the vapor pressure, in mm Hg of water above a solution that is 3.500 m glucose, C6H12O6

  Calculate the mole fraction of toluene in a solution

Toluene is a liquid compound similar to benzene. Calculate the mole fraction of Toluene in a solution that contains 112 g Toluene and 221 g Benzene.

  Explain what are the partial vapor pressures of a

The initial distillate was analyzed and found to contain 20 mole percent A and 80 mole percent B. What are the partial vapor pressures of A and B in the initial mixture

  State what was the temperature of the container

The total pressure of the container after the water condenses (5C) is .857 atm. What are the partial pressures of the 4 gases at 5C. e)What was the temperature of the container in Kelvin before it was cooled to 5C?

  Determine the molarity of a saturated nai sodium iodide

determine the molarity of a saturated nai sodium iodide solution aqueous formed as twenty five degree celsius

  Explain standardizes naoh titrant solution with khp

A student standardizes his NaOH titrant solution with KHP. He performs three titrations - in each trial, the mass of KHP (204.22 g/mol) used is 1.500 g. The average amount of NaOH used in the standardization is 29.3 mL +/- 0.06 mL.

  What is kp for this reaction

A reaction initially contains 0.1 moles of H2(g) and I2(g) in a 1L flask. At equilibrium the final concentration of HI(g) is 0.19M. What is Kp for this reaction.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd