Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 10,000 ft3 mass of saturated clay had a void ratio of 0.962 and a specific gravity of solids of 2.71. A fill was then placed over this clay, causing it to compress. However, the volume of the solids remained unchanged. After this was complete, the void ratio has become 0.758.
(a) Compute the initial and final moisture content of the clay.
(b) Compute the new volume of the clay.
(c) Compute the volume of the water squeezed out of the clay.
a 200 lb homogeneous gate of 10 ft width and 5 ft long is hinged at point a and held in place by 12 ft long brace as
knowing that the velocity of the package is 2 m/s when it is 8 m from the spring and neglecting friction, determine the maximum additional deformation of the spring in bringing the package to rest
The soil properties are Cc = 0.4, Cr = 0.1 and fsat = 18 kN/m3 for both clays, and the water table is 1 m below the soil surface. Determine the settlements when a stress of 60 kPa is applied by the building.
Two reservoirs are connected with a 30" diameter pipe with a length of 19,680 ft. The water surface elevation in the upper reservoir of the upper reservoir is 984 ft, lower reservoir 886 ft and the elevation at the midpoint is 918 ft.
You fill a 2 cubic foot wheelbarrow to the top with aggregate. If the specific gravity of the aggregate is 2.548 and 18% of the aggregate is void spaces, how much does the aggregate in the wheelbarrow weigh
An automobile company is planning to build a 1.8 million square foot factory in Auburn. Estimate the expected number of trip ends at the factory on an average weekday.
Two towers A and B are located on flat ground and their bases have equal elevations above sea level. A person on tower A whose eye level is 26.0 ft above the ground can just see the top of tower B, which is 105 ft above the ground. How far apart a..
Long Line: the slope distance and zenith angle measured from point a to point b were 17,685.20 ftand 93degrees 13' 46" . The instrument and reflector heights were equal. If the elevation of the point A is 1854.43 ft above the MSL Datum
The motion of a box on a spiral conveyor is defined by the following position vector: r = 0.5sin(2t) i + 0.5cos(2t) j - 0.2t k where r is in meters and t is in seconds. Find the location, velocity, and acceleration when t = 0.8 s.
Stadia is used to estimate the distance from the instrument to a target. Using inclined sights the horizontal distance and vertical distance between the center of the instrument and the target
Compare the reactor volume required to achieve 95% efficiency for Completely Mixed Flow Reactor (CMFR) and a Plug Flow Reactor (PFR) for the following conditions. steady-state, first-order reaction, flow rate = 14m3 / day.
If a hook can sustain a maximum withdrawal force of 250 N inthe vertical direction, determine the maximum tension, T, that can be exerted.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd