Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A certain element of soil is subject to a mean normal stress of 420 kpa and a deviator stress of 280 kpa. The major principal plane is rotated 30 degrees counterclockwise from horizontal. Draw the Mohr circle for this soils element, locate the pole and compute the normal and shear forces acting on horizontal and vertical planes.
When water at 70C flows through a convergingsection of pipe, the pipe pressure decreases in the direction of flow. Estimate the minimum absolute pressure that can develop without causing cavitation.
A pipe is to be installed under the ground on a bed of aggregate 6 in. thick. The entire weight on the aggregate from pipe and soil above the pipe is 1800 lbs. per linear foot of pipe. What is the pressure on the soil if theta is 45 degrees
Estimate the steady state PM10 concentration assuming a PM10 deposition velocity of 0.12 cm/s, prevailing wind velocity of 2.5 m/s, and a constant emission flux of PM10 0.82 mg/m2-s.
A rectangular steel bar shown is fixed at the right end has a thickness of 20 mm. The temperature is increased by 20C and a force F is applied as shown midway along the bar. Use the properties E=200 GPa, a=12(10^-6)/C.
A confined aquifer has a specific storage of 2.5*10^-6 ft^-1 and a thickness of 200 ft. How much water would it yield if the water declined 5.5 ft uniformly over a circular area with a radius of 1000 ft
The overhang beam has been fabricated with a projected arm BD on it. Draw the internal shear force, bending moment, and normal force diagrams for the beam ABC if it supports a load of 800 lb.
how to use the bisection method on the van der waals equation Problem 1 (15 Points) The van der Waals equation gives a relationship between the pressure P (in atm.), volume V (in L), and temperature T (in K) for a real gas
Obstruction due to underground electric lines requires that the x coordinate location of point C must be three feet as shown in the figure, as opposed to 1.5 ft for point B. Determine the magnitude of the resultant of the two forces
A continuous geogrid having a reinforcement coverage ratio equal to 100 percent. A continuous metallic grid consisting of W4 bars having a diameter equal to 5.7 mm, a distance between longitudinal bars equal to 150 mm, a distance between transvers..
Design a cord (design the constants k and ) so the cord stretches 2.5 times the unstretched length, and the acceleration of the jumper doesn't exceed 3g, and the cord has zero stiffness at the bottom of a 400ft drop.
Determine the (a) the coefficient of statics friction between the hawser and the bollard. (b) the number of times the hawser should be wrapped around the bollard if a 20000 pound force is to be resisted by the same 80 pound force
Two pounds of an ideal gas are contained within a piston-cylinder arrangement. The initial volume and pressure are 1 ft3 and 75 psia respectively. The final volume is 3 ft3.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd