User Account

All Pages

Complete level book entries and calculate reduced levels

Assignment Help Civil Engineering
Reference no: EM13275840

The Level Book extract below shows results of a closed level traverse around a property that picks up levels of the ground and some features around the property boundary.

1821_Determine the level miselose.png

a. Complete the Level Book entries and calculate the reduced levels.

b. Determine the level miselose.

c. Determine the maximum allowable misclose for this engineering survey using the formula based on the munber of instriunent stations used in the work.

d. Calculate the adjustments required if the misclose is acceptable.

e. Apply the adjustments and prepare a list of reduced levels for the Pegs/Marks A to K.

Attachment:- Workbook-Questions1.jpg

Reference no: EM13275840

Questions Cloud

What volume would the helium occupy : a helium tank holds 0.62m^3 of heliumat a pressure of 910 kPa. What volume would the helium occupy
Calculate the final rms speed of the hydrogen molecules : One mole of hydrogen gas at 22 C is compressed through an isobatic process to half its original volume
Define the system outputs the four bits of the unique stream : The system receives three binary streams: A, B, and C. The system takes a look during each clock cycle at the last four bits of each stream (a(t), a(t-1), a(t-2), a(t-3)), (b(t), b(t-1), b(t-2), b(t-3)) and (c(t), c(t-1), c(t-2), c(t-3)).
Estimate the temperature at which water boils : If the air pressure at a particular place in the mountains is 0.75 atm estimate the temperature at which water boils
Complete level book entries and calculate reduced levels : Determine the maximum allowable misclose for this engineering survey using the formula based on the munber of instriunent stations used in the work.
Find the total work done on the block : Albert is pulling a 25.0 kg block up a hill which has an angle of ï?± = 15.50, calculate the work done by each force listed, and thus find the total work done on the block
Design a network that accepts as input unsigned 8-bit number : Design a network that accepts as input one unsigned 8-bit number (which refreshes every clock cycle and is never 0) and keeps a running sum until the sum exceeds 1000. The network outputs both the sum and the number of additions required to reach ..
Explain how many grams of antique brass : If antique brass is 30.0% zinc and 70.0% copper, how many grams of antique brass can be made from 18.0 grams of zinc and 35.1 grams of copper
Estimate the initial speed of the bullet : A bullet of mass 5.00g is fired horizontally into a wooden block of mass 1.17kg resting on a horizontal surface. What was the initial speed of the bullet

Reviews

Write a Review

Civil Engineering Questions & Answers

  Define data mining confusion matrix

Suppose that you issued a query against a search engine and the search engine retrieved 125 documents. Suppose that there are total, Define Data mining confusion matrix

  Isotropic and homogenous hydraulic conductivity

Assuming an isotropic and homogenous hydraulic conductivity of 0.0001 cm/s what is the magnitude and direction of specific discharge (q)?

  How can a partnership be dissolved

What steps must be taken to set up a partnership? How can a partnership be dissolved?

  Assist structural engineer for a bridge replacement project

You should provide the structural engineer with a formal typed report that will include all of your analyses and final size of the footing. You should also include all of your design assumptions in your report.

  What is the percent yield

Carbon disulfide (CS2) reacts with excess chlorine (Cl2) to produce carbon tetrachloride (CCl4) and disulfur dichloride (S2Cl2). If 69.7 g of CS2 yields 62.6 g of CCl4, what is the percent yield? (Hint, you must first write the balanced equation.)

  Explain what is the cost breakdown structure

What is the cost breakdown structure(CBS)? What are its purposes? What is included (or excluded)? How does it relate to a work breakdown structure (WBS)?

  Velocity profile from the pipe wall

Compute points on the velocity profile from the pipe wall to the centerline of a 3/4-in Type K copper tube if the volume flow rate of water at 60 degrees F is .50 gal/min.

  Resulting center of gravity

The section of the plywood in the 3rd quadrant is sawed off and the resulting piece is then glued squarely over the 4th quadrant portion of the plywood with glue of negligible weight.What are the x- and y-coordinates of the resulting center of gra..

  Possible characteristic or property of sanstone

Give one possible characteristic or property of sanstone and of the quartzite that made you decide not to select it for your concrete project?

  Determining specific gravity

The cross sectional dimensions of a 4-ft-long wood member at 30% moisture content is 1.5 in. x 7.5 in., and its weight is 11 lb. At oven-dry condition, its dimensions and weight are 1.35 in x 6.8 in., and 10.2, respectively. What is its specific g..

  Resultant force from all fluids

A tank is filled with oil (specific gravity 0.8) and water to a depth of 10 meter and 6 meter respectively. Find the resultant force from all fluids acting on the gate of 1.8 meter by 9 meter.

  Coefficient of static friction between pacakges

The belt starts from rest at time t=0 and its speed increases at a constant rate of 150mm/s^2. Knowing that the coefficient of static friction between the pacakges..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd