### Compare your predictions with the measured fatigue crack

Assignment Help Civil Engineering
##### Reference no: EM131069711

Consider the crack growth results shown in Fig. 11.10 for the alumina silicon carbide composite at 1400 °C. Using the procedure outlined in Section 11.2.2 predict the crack growth characteristics under cyclic loads on the basis of the static crack growth results by assuming that the mechanisms of static and cyclic fracture are the same at the elevated temperature. Compare your predictions with the measured fatigue crack growth rates for both frequencies and discuss possible reasons for the discrepancies, if any, between your predictions and the experimentally determined growth rates.

### Write a Review

#### A rectangular clarifier with a lengthwidth ratio of 31

a rectangular clarifier with a lengthwidth ratio of 31 receives a flow of 850m3day. the clarifiers depth is 4.0m and

#### Determine the average impact force which is exerted on body

the coefficient of the restitution for the collision is e = 0.3, and friction is negligible. if the time duration of the collision is 0.025 s, determine the average impact force which is exerted on the 3 kg body.

#### What kind of soil labs are good for the construction

What kind of soil labs are good for the construction which is underlying the wet clay is dense sand. For example, compaction, and so on.

#### What dilution rate would be required to control the do sag

At a plant making MSG (monosodium glutamate) for use inAsian cooking the waste stream discharged to a nearby streamcontains 100 mg of glutamic acid(C5H9O4N) per liter.

#### Determine the maximum compression of the spring

The 30-Mg freight car A and 15-Mg freight car B are moving toward each other with the velocities VA= 20 km/h to the right and VB= 10 km/h to the left. the spring constant on car A is k= 3MN/m.

#### Determine the velocity in horizontal x-y plane

A particle with a mass of 0.5 kg has a velocity of 10 m/s in the x-direction at time t = 0. Forces F1 and F2 act on the particle, and their magnitudes change with time according to the graphical force-time history shown.

#### Whether the project is economically stable

A project is being considered, benefits and costs are: Initial cost = \$100,000. Additional cost at the end of year 1 = \$50,000. Benefit at the end of year 1 = \$0. Annual benefits at the end of Years

#### Determine the control efficiency needed to meet the criteria

A Chemical manufacturer emits air with 250 PPM of toluene at 1 atm and 30 degrees C at a flow rate of 10,000 cubic meters per minute.The air is routed to a biofilter to control total emissions to less than 110 kg/day of toluene.

#### What volume of sludge must digester dispose of each year

WHat volume of sludge must they dispose of each year if their sand drying beds yield a solids concentration of 35%

#### What was the distance between the markers

A 100 ft cut steel tape was used to measure between two property markers. The rear surveyor held 93 ft, while the head surveyor cut .67ft. What was the distance between the markers?

#### Does the steel have adequate charpy v notch fracture tough

A Charpy V Notch test was conducted for an ASTM A572 Grade 50 bridge steel. the average values of the test results at four different test temperatires were found to be 10ft.lb -(-50 F) 15 ft.lb- 0F 40 ft.lb- 40F 60 ft.lb-100 F

#### What features might you look for on the fracture surfaces to

Manufacturing process that unintentionally introduces cracks to the surface of a part was used to produce load-bearing components. The design requires that the component be able to withstand a stress of 450 MPa. The component failed catastrophically ..