Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Compare the by hand solution and the PSPICE simulation for a voltage amplifier which has an input resistance of 10kohms and an output resistance of 100ohms, and a gain of 100V/V. The voltage amplifier is capacitively coupled to a voltage source with an internal resistance of 100ohms. The load resistance is 69ohms. Make the input coupling capacitor 10uF and put a capacitor in parallel with the load of 10nF. Perform an ac sweep from 1Hz to 10MHz and plot the voltage gain.
Using the table, what is the byte stored at address 2F? Using the table, what is the byte stored at address 33?
What is the total number of electrons transported from the positive electrode to the negative electrode by the charge escalator from the time the battery is first used until it is completely dead?
An AC sine wave is applied to the input of a full wave rectifier. The output of the full wave rectifier is then applied to a half wave rectifier.
What is the modulation used to transmit HDTV signals over the air in US terrestrial broadcasting? What is the transmitted bit rate and the compression method?
Design the combinational logic circuit for an elevator controller such that the option to go up or down by only one floor is disabled. Assume that the building the elevator is in has 4 floors. Your inputs are the current floor and the next request..
Find the characteristics equation and the corresponding roots for the following ODEs and identify its case a) y" + 6Y' + 9y=0 b) 10y" + 18y' +5.6y=0 c) 10y" + 50y' + 65y =0 Slove the intial value problem a) problem 2a) with y(0)=2 and y'(0)=-5
What is the attenuation per octave between 1 kHz and 10 kHz? What is the increase in attenuation between 5 kHz and 10 kHz?
A dc separately excited generator runs at 1200 rpm. the rated current and voltages are 100 A at 240 V. The armature resistance is 0.15 (ohms). The open circuit magnetization characteristics at 1200 rpm are
Consider a network with a driving-impedance Z. (1) Find expression for P and Q. (2) Find p(t) in terms of P and Q. (3) Suppose that the network is a series RLC. Interpret the result in part (2).
Design a circuit that will add either 1 or 2 to a 4-bit binary number N. Let the inputs N3, N2, N1, N0 represent N. The input K is a control signal. The circuit should have outputs M3, M2, M1, M0, which represent the 4-bit binary number M.
Assume that in addition to the sine-wave signal you have a dc reference voltage of 1.5 V available. Sketch the output signal waveform.
Using this method, create and test a minority vote circuit, a circuit designed to indicate when one or no inputs are HIGH. Determine the appropriate SOP equations, enter, compile, simulate, download, and test your solution.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd