Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
If given a brittle material with a known tensile strength, Sut, and a known compressive strength, Suc, use the four main fracture criteria (MNSC, BCM, MM, and MIIM) to determine the shear stress, tau, in terms of the material properties Sut and Suc. Compare and contrast the formula resulting from each theory.
An excavation is proposed for a site consisting of a homogenous, isotropic later of silt clay, 14.24 m thick, above a deep deposit of sand. The groundwater is 2m below ground level outside the excavation. The groundwater level inside the excavatio..
You are to assume that seawater at 77oF will be used in the tank and the curved portion forms a quarter of a circle. The tank is open to the atmosphere. The overall height, h2, is 20ft deep. The radius of the curve, R, is 5ft. The width of the..
Roughly what is the maximum Volume of treated wastewater should you put in the bottle if you want to have at least 2.0mg/l of DO at the test (filling the rest of the bottle with the water
If the maximum total acceleration of the train must not exceed 1.5 m/s^2, determine the shortest distance in which the train can reach a speed of 72 km/h, and determine the corresponding constant rate of acceleration at.
The casting has a mass of 3Mg. Suspended in a vertical position and initially at rest, it ia given an upward speed of 200mm/s in o.s^s using a crane hook H. Determine the tension in cables AC and AB during this time interval if acceleration is con..
Describe some of the benefits of physical models and mock-ups. What data are required to measure the following cost-effectiveness, system effectiveness, operational availability, and life-cycle cost?
A 1 m diameter unfinished concrete pipe (n = 0.015) has a slope of So = 0.001 and conveys water at Q = 0.5 m3/s. Find the normal depth yo and critical depth yc.
Determine the design hourly volume for the road below, recommend the K factor first.
A quartzite sample in a compression testing machine is 180mm long and 54mm in diameter. what is the stress under a load of 100kN? if the modulus of elasticity is 102kN/mm2, find the strain develope in the sample.
design a horizontal curve for a two lane road. The road has 12 ft. lanes. Due to expensive excavation, it was determined that a maximum of 34 ft. can be cleared from the roads centerline towards the inside lane to provide for stopping sight distan..
A 3-mm thick panel (1 m x 1 m) of aluminum alloy (k = 177 W/m. K, Cp = 875 J/kg. K, and p(rho)= 2770 kg/m3) is heated in a large oven with air at T = 175oC and a convective heat transfer coefficient of h = 40 W/m2.K.
for a uniformly loaded square area, what is the stress to load ratio at a depth of 2B below the CENTER of the loaded area
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd