Claculate the network real and reactive powers

Assignment Help Electrical Engineering
Reference no: EM13226774

A 150 MVA, 24 kV, 125% three-phase synchronous generator supplies a large network. The network voltage is 27 kV. The generator operates with an induced voltage, which is twice the rated line-to-neutral voltage. The phase angle between the network voltage and induced voltage is 56 degrees. Claculate the network real and reactive powers.

Reference no: EM13226774

Questions Cloud

Contrast cdma techniques with frequency hopping : CDMA is a multiple access technique to allow multiple users to share the same bandwidth, based on the orthogonality of their spreading codes. CDMA is a descendent of the direct sequence spread spectrum (DSSS) technology designed for antijam (AJ).
Explain what is steam distillation : what is steam distillation and why is it a preferred technique to purify high boiling liquids that are water-insoluble
Why latter functions of two variables should be implemented : Implement switching function of 4 variables H(A,B,C,D)= AB'+BC+A'CD using a 4 to 1 Multiplexer and any number of 2 to 1 multiplexer. One can select any 2 variables (for example, AB or CD) as select inputs of one 4 to 1 multiplexer.
State what is the ph of the original buffer and after hcl : Calculate the pH of 1.00 L of a buffer that is 0.140 M HNO2 and 0.180 M NaNO2. What is the pH of the same buffer after the addition of 1.00 mL of 12.0 M. HCl. (pKa of HNO2 = 3.40). What is the pH of the Original buffer and after HCl is added?
Claculate the network real and reactive powers : A 150 MVA, 24 kV, 125% three-phase synchronous generator supplies a large network. The network voltage is 27 kV. The generator operates with an induced voltage, which is twice the rated line-to-neutral voltage.
Calculate power angle if network receives an inductive power : The network voltage is 27 kV. The generator operates with an induced voltage, which is twice the rated line-to-neutral voltage. Calculate the power angle if the network receives an inductive reactive power of 50 MVA.
Explain what are the equillibrum pressure of pco : The value of Kc for this reaction is 5.0 at 600 K. What are the equillibrum partial pressures of the three gases if a reaction vassel initially contains a mixture of the reactants in which Pco=Pcl2=0.215 atm and Pcocl2= 0.000 atm?
Explain observed in a mass-spectrum of a parent peak : The following isotopic cluster was observed in a mass-spectrum of a parent peak of a halogenated compound:
Development of accounting : what extent can these events you identified in part a) be used to argue that accounting can have an influence on society?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the instantaneous power

RC ciruit= Current course (3u(-t) A) in parrallel to 6k ohm resistor and 5uF cap. Determine the instantaneous power absorbed by the resistor at t=(0); 30ms; and 90ms.

  What is an open collector input why is it used on sensors

Draw a strain gauge circuit and its external components to attach to a conveyor mounted only at the ends to measure the load at the center of the conveyor. What type of testing would you need to do to establish a baseline and calibration curve for..

  Find the nonzero value

Find the nonzero value of ω for which the expression for Z(ω) given is purely real. Give your answer as a function of R, L, and C.

  What is the magnitude and direction of the current flowing

what is the magnitude and direction of the current flowing through the cross section?

  What is the conversion efficiency of an amplifier

What is the conversion efficiency of an amplifier in which the effective value of the current through a 2.2-k? load is 5 mA and the drain on the 18-V dc supply is 3.8 mA

  What is signal to noise ratio at the output of the amplifer

Assume you have a receiver with an overall noise figure of 23 dB and a bandwidth of 1 MHz. Assuming the minimum acceptable SNR at the output of the receiver is 6 dB, estimate the minimum detectable signal level in dBm at the receiver input.

  Write an instruction sequence

Write an instruction sequence to set bits 3, 2, 1, and 0 of memory location at $1000 to 1 and leave the upper four bits of the same locations unchanged. use hcs12/9s12 to program.

  Find out the voltage level required

A microwave system requires a +4-dBm audio level to provide 100% modulation. Determine the voltage level required if this is a 600 ohm audio system.

  Define in comparing the behaviour of an n-channel mosfet

In comparing the behaviour of an n-channel MOSFET with a p-channel device having identical geometry and threshold voltage, it is found that the n-channel FET has a greater drain current than that of the p-channel FET.

  What is the value of the smallest resistor

The voltage drops across three resistors in series are measured to be 10.0V, 15.0V, and 25.0V. If the largest resistor is 47.0 ?, what is the value of the smallest resistor?

  What is energy stored at switch closed

For a RL circuit, write a diffedrential equation in which the only time dependant quantity is current (use Kirchoff's loop). Derive an expression for current, i(t), in terms of L,R, and Vo. If Vo=5V, R=2.5 ohms, L=100 nH

  Consider a chip design using mask levels

Consider a chip design using 10 mask levels. Suppose that each mask can be made with 98% yield. Determine the composite mask yield for the set of 10 masks.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd