Calculate power angle if network receives an inductive power

Assignment Help Electrical Engineering
Reference no: EM13226773

A 150 MVA, 24 kV, 123% three-phase synchronous generator supplies a large network. The network voltage is 27 kV. The generator operates with an induced voltage, which is twice the rated line-to-neutral voltage. Calculate the power angle if the network receives an inductive reactive power of 50 MVA.

Reference no: EM13226773

Questions Cloud

Explain what is steam distillation : what is steam distillation and why is it a preferred technique to purify high boiling liquids that are water-insoluble
Why latter functions of two variables should be implemented : Implement switching function of 4 variables H(A,B,C,D)= AB'+BC+A'CD using a 4 to 1 Multiplexer and any number of 2 to 1 multiplexer. One can select any 2 variables (for example, AB or CD) as select inputs of one 4 to 1 multiplexer.
State what is the ph of the original buffer and after hcl : Calculate the pH of 1.00 L of a buffer that is 0.140 M HNO2 and 0.180 M NaNO2. What is the pH of the same buffer after the addition of 1.00 mL of 12.0 M. HCl. (pKa of HNO2 = 3.40). What is the pH of the Original buffer and after HCl is added?
Claculate the network real and reactive powers : A 150 MVA, 24 kV, 125% three-phase synchronous generator supplies a large network. The network voltage is 27 kV. The generator operates with an induced voltage, which is twice the rated line-to-neutral voltage.
Calculate power angle if network receives an inductive power : The network voltage is 27 kV. The generator operates with an induced voltage, which is twice the rated line-to-neutral voltage. Calculate the power angle if the network receives an inductive reactive power of 50 MVA.
Explain what are the equillibrum pressure of pco : The value of Kc for this reaction is 5.0 at 600 K. What are the equillibrum partial pressures of the three gases if a reaction vassel initially contains a mixture of the reactants in which Pco=Pcl2=0.215 atm and Pcocl2= 0.000 atm?
Explain observed in a mass-spectrum of a parent peak : The following isotopic cluster was observed in a mass-spectrum of a parent peak of a halogenated compound:
Development of accounting : what extent can these events you identified in part a) be used to argue that accounting can have an influence on society?
Calculate the three-phase steady-state short-circuit current : A 150 MVA, 24 kV, 123% three-phase synchronous generator operates with an induced voltage that is twice the rated line-to-neutral voltage. Calculate the three-phase steady-state short-circuit current at the generator terminals.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Consider a direct sequence spread spectrum

Consider a direct sequence spread spectrum (DSSS) system attempting to transfer data. The DSSS system has a data rate of 2 Kbps (2 thousand bits/sec) which is spread to 2 Mcps

  Determine the noise on the output as percent fs

A system is needed to measure flow, which continuously cycles between 20 and 30 gal/min with a period of 30 sec. The required output is a voltage varying from -2.5 to +2.5 V for the cycling flow range. The sensor to be used has a transfer function..

  How the reverse movement of the motor be controlled

Design I/O wiring to control forward and reverse 12Vdc motor using PLC OMRON CJ1M. Consider that the forward movement of the motor will be controlled by a forward button and the reverse movement of the motor will be controlled by a reverse button

  Calculate the distance

Calculate the distance, D at which communication from the space craft will be lost again? Assume both antennas are ideal.

  Shielding effectiveness with copper also steel at equality

Shielding Effectiveness with copper and steel at equality, Determine the frequency at which two 1 mm thick shields, one made of copper and the other of steel

  An ac sine wave is applied to the input of a full wave

An AC sine wave is applied to the input of a full wave rectifier. The output of the full wave rectifier is then applied to a half wave rectifier.

  Calculate the average torque and maximum torque

When the two windings are connected to a a.c supply of 50hz, the field current is 0.1A, the armature current is 100A and the phase difference between them is 60 degree. calculate the average torque and maximum torque.

  Dispense requested amount using least number of bills

Dispense requested amount using least number of bills, Write a C program for an automatic teller machine that dispenses money. The user should enter the amount desired (a multiple of 10 dollars)

  Define the problem on rankine cycle

Water is the working fluid in a vapor power cycle with reheat, superheat and reheat. Superheated steam enters the first turbine stage at 8 MPa, 480 C and expands to 0.7 MPa

  What current in amperes will flow through the bulbs

A 100 W bulb takes 0.833A and a 200 W bulb takes 1.67 A from a 120V source. If the two bulb were connected across a 240 V source, what current in amperes will flow through the bulbs?

  Find the maximum acceleration that can be measured

An LVDT (Linear Variable Differential Transformer) is used in an accelerometer to measure seismic-mass displacement. The LVDT and signal-conditioning output is 0.31 mV/mm with a +/- 2 cm maximum core displacement.

  Solve problem in control signal processing class

Help with problem in Control signal processing class, Consider the unity-feedback control system whose open-loop transfer function is

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd