Calculate work done, Tank A has a volume of 100 liters and

Calculate work done

Reference no: EM13557113

Tank A has a volume of 100 liters and contains saturated vapor r-134 at 30C. With the valve open slightly flow enters cylinder B. a pressure of 200kpa is required to lift piston in b. the process ends when the pressue at A drops to 200kPa. during this process all r-134a is at 30c because of heat transfer.

calculate A) work Done b ) Heat transfer

Reference no: EM13557113

Questions Cloud

Show how the gibbs energies of each of these phases : The standard molar entropies of water ice, liquid and vapor are 37.99, 69.91, and 188.83 J K-1mol-1, respectively. On a single graph, show how the Gibbs energies of each of these phases vary with temperature between – 20 C and 150 C

Calculate the maximum mixing height in meters : Compute the critical buckling load for a 2.5m timber column of full size square section 0.10m x 0.10m. The column has pinned ends(k=1). Assume the modulus of elasticity is 12Gpa and that the Euler formula applies.

Determine a composite scs runoff curve number : Determine a composite SCS runoff curve number for a 600-acre basin that is totally within soil group C. The land use is 40 percent contoured row crops in poor hydrologic condition and 60 percent native parture in fair hydrologic condition.

What is the firms cost of capital before taxes : A firm's stockholders expect a 15% rate of return, and there is a $12M in common stock and retained earnings. The firm has $5M in loans at an average rate of 7%. The firm has raised $8M by selling bonds at an average rate of 6%. What is the firm's co..

Calculate work done : Tank A has a volume of 100 liters and contains saturated vapor r-134 at 30C. With the valve open slightly flow enters cylinder B. a pressure of 200kpa is required to lift piston in b. the process ends when the pressue at A drops to 200kPa.

What is the elongation of a rectangular bar : What is the elongation of a rectangular bar (cross section 2 inch * 2 inch length 4 ft) When it is subjected to an axial load of 80,000 lbs. Assume the material of the bar has the following properties G = 7,700 KSI, V =0.30

Calculate the active and passive pressures at the lower end : A line of sheet piling is driven 4m into a firm clay and retains, on one side, a 3m depth of fill on top of the clay. Water table level is at the surface of the clay. The unit weight of the fill is 18kN/m3 and the saturated unit weight of the clay is..

Determine the factor of safety with respect to shear failure : A footing 3m X 3m carries a pressure of 500 kN/ m2 at a depth of 1m in a sand substrate. The saturated unit weight of the sand is 20 kN/ m3 and the unit weight above the water table is 18 kN/ m3

What is the allowable slope angle if a factor of safety : A cutting 9 m deep is to be excavated in saturated clay of unit weight 19 kN/m3. The design shear strength parameters are cu = 30 kN/ m2 and u = 0. A hard stratum underlies the clay at a depth of 11 m below ground level.

User Account

All Pages