Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The specification for the diameter of a hole is .75 inch ± .015 inch. The standard deviation of the drill press is .007 inch. Using Cp, calculate whether the process is capable or not.
A Timber power-line pole is 10 in. in diameter at its base where it is solidly embedded in concrete. The pole extends 20 ft vertically upward from its base and is subjected to a horizontal pull of 300 lb at its top.
a timber beam 6 in. wide by 12 in. deep is loaded and supported as shown below. the modulus ofnbspelasticity of the
The coordinates for station A are 1023.34 N and 988.56 E. What are the northing and easting coordinates for station B that is located 40 feet due east of A, and 22.32 feet due south of A
assume lateral support at each support and every 20 ft between supports. assume constant depth for girder. use A 572 grade 50steel. use LRFD methods. minimum web thickness is 5/16 inches.
Aluminum ion (Al3+) is present in an industrial wastewater at 3 mg/L. The treatment facility wants to precipitate out the aluminum until there is only 0.2 mg/L remaining. What pH is required to acheive this aluminum ion concentration
Is a soil with a hydraulic conductivity of 1*10-5 cm/s and depth of 10 ft equivalent to a soil with hydraulic conductivity of 1*10-6 cm/s and depth of 5 ft
Discuss how the NEC3 form of contract provides stimulus to good management and compare and contrast this where possible with other forms of contract.
Explain what you observe, how an engineer can use this information, and detail your findings in a brief paper no longer than 10 pages. You may work in a group of up to 3.
The design wind speed is 15 mph at T=10C and p=0.9 bar. The efficiency of the turbine is n=20% meaning that 20% of the kinetic energy in the wind can be extracted. estimate the power in watts that can be produced by the turbine.
The power winches on the industrial scaffold enable it to be raised or lowered. For rotation in the senses indicated, the scaffold is being raised. If each drum has a diameter of 200 mm and turns at the rate of 40 rev/min. determine the upward vel..
Using the data provided, determine the volume fraction of fibers that will be required. What will be the tensile strength of this composite? Assume that the matrix stress at fiber failure is 50 MPa (7250 psi)
Define an Fe-C martensite. (b) Describe the following types of Fe-C martensites that occure in plain-carbon steels: (i) lath martensite, (ii) plate martensite. (c) Describe some of the characteristics of the Fe-C martensite
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd