Calculate total co2 emissions from two polices

Assignment Help Civil Engineering
Reference no: EM13559237

Two changes to the CAFE standard for US automobiles are being considered. A more conservative increase from 27.5 mpg in 2011 to 35 mpg by 2020 is supported widely in Washington. California and 13 other states + the District of Columbia hope to increase that stander to 35 mpg by 2017 and 40 mpg by 2020. Calculate total CO2 emissions from two polices from 2011 to 2020 in kg of CO2 for a fleet of 240 million cars (all the cars in the US). Assume that all cars are driven 10,000 miles/year. Model gasoline as octane (with the chemical formula C8H8) and assume it has a density of 0.7 g/ml.

Total CO_2 emission from conservative CAFE: _________

Total CO_2 emission from aggressive CAFE: ___________

Reference no: EM13559237

Questions Cloud

Design a hollow steel shaft with an inside diameter : Design a hollow steel shaft with an inside diameter 1/3 that of the outside diameter. The shaft transmits 200 kW at a speed of 20 Hz. The allowable shearing stress is 55 MPa, and the allowable angle of twist is 1 degree per meter of length.
Estimate the capacity of the existing system : You meet with a potential client to discuss a land development project. Your client wants to know the capacity (in cfs) of the existing water supply system serving the area With a 450-ft pipeline
Find how many protons are absorbed by the tumor : A cancer patient is undergoingradiation therapy in which protons with an energy of 1.2 MeV areincident on a 0.25 kg tumor. How many protons are absorbed by the tumor
What would the height be after it was consolidated into this : There is a perfectly uniform soil that is an assemblage of spheres of equal diameter. A 1m thick layer of this soil is packed so that it is as loose as possible (void ratio, e_max ~= 0.9),
Calculate total co2 emissions from two polices : Two changes to the CAFE standard for US automobiles are being considered. A more conservative increase from 27.5 mpg in 2011 to 35 mpg by 2020 is supported widely in Washington. California and 13 other states + the District of Columbia hope to increa..
How much of a reduction in the automobile emission rate : How much of a reduction in the automobile emission rate would be required to achieve the maximum eight-hour average NAAQS for CO at steady state 9 ppmv ( (10.3 mg/m^3)?
Obtain from what height above ground was the marble thrown : A marble is thrown horizontally with a speed of 13 m/s from the top of a building. From what height above the ground was the marble thrown
What is the fuel consumption under these conditions : First consider highway driving. Assume a constant velocity of 27 m/s (60.4 mph) on level ground. Under these conditions the efficiency of the engine plus auxiliaries is 30 percent and the efficiency of the drivetrain is 85 percent. What is the fuel c..
Demonstrate the relationships between mortals and the gods : how do the differnt cultures, which we have studied, demonstrate the relationships between mortals and the gods? This in terms of creation, interaction, the flood, etc.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find required size of new schedule 40 steel pipe to carry

Determine the required size of new Schedule 40 steel pipe to carry 0.5 cfs (Q = 0.5 cfs) of water at 160o F with a maximum pressure drop of 10 psi per 1,000 ft.

  Determine the acceleration of the first two drivers

Three stock car drivers are racing around a circular bend. They are each circling the bend at different radii: r(1)=249 m , r(2)=255 m , and r(3)=261 m . At a given instant, all three are traveling at the same transverse rate of rotation

  Find area of steel reinforcement required for concrete tbeam

Find the area of steel reinforcement required for a concrete T-beam for the following data; f'c = 3 ksi, fy=60 ksi,d=18 in, t= 4.5 in., bw= 10 in., bf= 36 in., 3/4" aggregate, and the section sustains a total factored bending moment 82 k-ft.

  What would be emissions of sulfur dioxide from having burned

if a residential space heater burns anthricite coal having a sulfur of 2.85% what would be the emissions of sulfur dioxide from having burned 900 ib of this coal. use ap-42 table 1.2-1 sulfur dioxide emission=[SO2] pounds.

  Determine what is speed of the car as it passes the light

If the motorist wishes to pass the light just as it turns green without having to stop, what is the required uniform deceleration of the car and what is the speed of the car as it passes the light

  Ensure that the maximum tractive effort developed for front

how far back from the front axle would the center of gravity have to be to ensure that the maximum tractive effort developed for front- and rear- wheel-drive options is equal (assume that all other variables are unchanged)

  Determine the volume flow rate of water

Water with a static pressure of 1.96kN/M 2 flows through an 800 mm diameter pipe. A pitot tube pressure gage in this pipe reads a pressure of 5.88 kN/M 2 . How do you determine the volume flow rate (Q) of the water? (Q = 1.40 M^3/sec, V=2.79 M/se..

  Determine time of queue dissipation and longest queue length

Finally, the wreckage is removed, and the freeway is restored to full capacity (4000 veh/h) at 8:31 a,. Assume D/D/1 queuing to determine time of queue dissipation, longest queue length, total delay, average delay per vehicle, and longest wait of ..

  Nighttime traffic on a single lane of rural highway is light

Nighttime traffic on a single lane of rural highway is light, with a flow of 40 vehicles/hour , and is well described by a Poisson arrival process.

  How is this optimal loading changed if the maximum truck

How is this optimal loading changed if the maximum truck speed is changed from 35 to 45 mph or to 25 mph? What would these changes do to the cost of this particular job?

  Determine the specific weight of wood above water surface

a solid wooden cube (.5*.5*.5 m^3) is floating in water and 0.2 of the cube extends above the water surface. Determine the specific weight of the wood.

  Calculate value of temperature that can increase efficiency

An engineering student, recognizing that the "ideal gas law" requires gas velocity to be function of temperature, suggests that an easy way to increase efficiency would be to change the temperature of the exhaust gas being treated.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd