Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Express the diode current equation. A) Define all the diode parameters and draw the I-V characteristics. (Assume non-ideal diode)B) If IF=10 mA, Is=10-15A, VT=25mV, Calculate the voltage drop across the diode.
1. What is the effect of sampling at a higher rate on the error performance of a digital modulation scheme 2. Suppose 16QAM was the modulation scheme used for this lab; would the error performance
Describe the operation of the series RC circuit. The discussion must address phase angle relationships of current and voltage. The answer must include the effect of source frequency on the voltage drops across the resistor and the capacitor at ver..
A potentiometer with a total range of 350° is supplied with a voltage of 12 Vdc. Find the output voltage for an angle of 135°. An absolute optical rotary encoder has five tracks. How many bits is the output
determine the current drawn from a 3 phase 220 V line by a 3 phase 15kW motor operating at half load, 85% efficiency and .8 pf lagging. Find the values of real and reactive power drawn from the line.
design the sign extension component of an I-Format Data Path Unit, where a 16 bit number will be extended to a 32-bit number, while mainintaing the sign (signed numbers use 2s complement).
with general block diagrams, show how to obtain the following frequencies from a 10 MHz clock by using single flip-flop, modulus-5 counters, and decade counters for 5MHz 2.5MHZ 2MHz 1MHz 500kHz 250 kHz 62.5 kHz 40 kHz 10 kHz 1 kHz
Assume you have a receiver with an overall noise figure of 23 dB and a bandwidth of 1 MHz. Assuming the minimum acceptable SNR at the output of the receiver is 6 dB, estimate the minimum detectable signal level in dBm at the receiver input.
An optical lithographic system has an exposure power of 0.3 mW/cm2. The required exposure energy for a positive photoresist is 140 mJ/cm2 and for a negative photoresist is 9 mJ/cm2. Assuming negligible times for loading and unloading wafers
A proportional control system is to be used to control the wing flap of a jet airplane. The wind load is expected to cause as much as 600 in-lb of torque. The system should be able to keep the flaps with 5o of the set point.
A 50HP single phase motor operates from a 480V, 60HZ supply. When delivering full rated power the motor efficiency is 89% and the power factor is 0.78 lagging. Determine the full load current.(Hint: 746W=1HP)
Two Random variables have a joint probability distribution function defined by F(x,y)=0 X 1y>1 A). Sketch this distribution function. B). Find the joint probability density function and sketch it.
Germanium is n-type doped at 5x1015 cm-3 at T=300 K. The dimensions of the Hall device are d=5x10-3 cm, W=2x10-2 cm, and L=10-1 cm. The current is Ix=250 A, the applied voltage is Vx=100 mV, and the magnetic flux density is Bz= 500
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd