Calculate the uncertainty in the differential temperature

Assignment Help Civil Engineering
Reference no: EM131344502

A thermopile of chromel-alumel with four junction pairs is used to measure a differential temperature of 4.0?F at a temperature level of 400?F. The sensitivity of the thermocouple wire is found to match that in Table 8.3 within ±0.5 percent, and the millivolt potentiometer has an uncertainty of 0.002 mV. Calculate the uncertainty in the differential temperature measurement.

262_9d43ecc7-5554-4a25-85d5-3be051cf0b81.png

Reference no: EM131344502

Questions Cloud

Select the values of l and c : The circuit in given Figure is a simplified diagram of a pulser that delivers simulated lightning transients to the test article at the output interface.
What does the gdp indicate about an economy : What does the GDP indicate about an economy? Can a GDP be manipulated and thus provide inaccurate information about a country's economic production
Concentration at the negative electrode : A concentration cell is constructed at 25 ºC based on the Zn/Zn2+ electrode. The concentration of Zn2+ is known to be 1.3 M at the positive electrode. If the cell voltage is initially 0.1049 V, what is the concentration at the negative electrode?
Describe three key elements of your merger plan : What are the key issues/challenges/opportunities you face, both short and long term? Describe three key elements of your merger plan.
Calculate the uncertainty in the differential temperature : The sensitivity of the thermocouple wire is found to match that in Table 8.3 within ±0.5 percent, and the millivolt potentiometer has an uncertainty of 0.002 mV. Calculate the uncertainty in the differential temperature measurement.
Mass of chlorine gas is produced by the reaction : Ammonia perchlorate (NH4CIO4) is solid rocket fuel. It reacts with itself to produce nitrogen gas (N2), chlorine gas (Cl2), oxygen gas (O2) water (H2O) and a great deal of energy. What mass of chlorine gas is produced by the reaction of 1.26g of a..
Explain the flow of money and goods in an economy : How economists are both scientists and policymakers and what principles society uses to allocate its scarce resources. Using the circular flow model, explain the flow of money and goods in an economy
Why would restaurants find the saas model very attractive : What characteristics of the restaurant market make it difficult for a reservation system to work? How did OpenTable change its marketing strategy to succeed? Why would restaurants find the Saas model very attractive?
Which inductor would you use in your design and why : RLC Circuit Design Losses in real inductors can be modeled by a series resistor as shown in given Figure.- Which inductor would you use in your design and why?

Reviews

Write a Review

Civil Engineering Questions & Answers

  A nozzle is designed to linearly accelerate the fluid

A nozzle is designed to linearly accelerate the fluid from V1 to V2 (i.e., V = ax +b, where a and b are constants). The flow at t = 0 is

  Calculate the heat transfer required to do quality in btu

A rigid 1ft^3 vessel contains R-134a originally at -20F and 27.7% quality. The refrigerant is then heated until its temperature is 100F. Calculate the heat transfer required to do this, in Btu.

  If the bearing stress on the concrete pedestal must not

If the allowable stress in the cylinder is 55 MPa, what is the maximum internal diameter (nearest integer, such as 10, 11, 12, …., in units of millimetres) of the cylinder?

  Calculate the depth of flow 2 km upstream of the dam

A 12.0 m rectangular channel, having a bed slope of 50 cm/km and a Manning roughness coefficient of 0.015, conveys water at a normal depth of 1.0 m. A dam is built across the channel at which the water depth is 2.0 m.

  Determine the increase in internal energy of the system

The only work interaction between the system and the surroundings is via the paddle wheel. The work done on the system via the paddle wheel is 220 ft*Ibf and the heat interaction can be assumed negligible.

  Determine the rate of flow-unconfined aquifer

In an unconfined aquifer having K = 30/m/day, two observation wells, 3km apart, have water levels of 50 and 40 m, respectively, above the base of the aquifer. Determine the rate of flow.

  Write out the equation for the decision boundary

Show that the decision boundary is a vector space. (Demonstrate that the 10 criteria are satisfied for any point on the boundary.)

  What is the current rate at which water enters and leaves

Assuming that minimal water is lost due to evaporation and the total volume remains constant, what is the current rate at which water enters and leaves the San Vicente reservoir?

  Determine the makeup of the mixture on a mass

determine the makeup of the mixture on a mass basis and the internal energy change per unit mass of mixture.

  Determine the power that can be produced

Determine the power that can be produced if the fresh water produced is mixed with the seawater reversibly.

  What was the shear stress on the failure plane at failure

At a confining pressure of 2000 psi, the first sample failed at 9000 psi. Then at a confining pressure of 5000 psi, the other sample failed at 21000 psi. (a) plot the 2 test results on a shear stress-nomal stress diagram and draw in the Mohr envel..

  What should be the outside diameter if the load is carried

A circular tube has a wall thickness of 10 mm. It is required to carry a load of 1000 kN with a factor of safety of 2.0. The length of the tube is 4 m. What should be the outside diameter if the load is carried in?:

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd