User Account

All Pages

Calculate the sag from the taller of the two supports

Assignment Help Electrical Engineering
Reference no: EM131217372

Write the answer of the given question:

An overhead transmission line conductor having a parabolic configuration weighs 1.925 kg/cm2 per metre of the length .The area of X-section of the conductor is 2.2 cm2 and the ultimate strength is 8000kg/cm^2. The supports are 600 m apart having 15 m difference of levels.

Calculate the sag from the taller of the two supports which must be allowed so that the factor of safety shall be 5.

Assume that ice load is 1 kg per metre run and there is no wind pressure.

Reference no: EM131217372

Questions Cloud

Prepare an overview of why the training is needed : Identify what the problem is and what type of training is being proposed. Relate this to the organization's strategic imperatives. Prepare an overview of why the training is needed. Include the learning objectives that you have identified for the p..
What is the efficiency of the motor at full load : Suppose that the motor is running at the no-load conditions described in part (e). What would happen to the motor if its field circuit were to open? Ignoring armature reaction, what would the final steady-state speed of the motor be under those co..
Determining acquisition cost for an asset acquired : Determining Acquisition Cost for an Asset Acquired in Exchange fora Note Payable. Assume that spring. field Foods, Inc. a custom-made refrigeration system by issuing a SI.500,000,10-year non-interest- acquired bearing note payable at a time when the ..
Calculate the sag from the taller of the two supports : Calculate the sag from the taller of the two supports which must be allowed so that the factor of safety shall be 5.
Determining acquisition cost in a basket purchase : Determining Acquisition cost in a Basket Purchase. Holman Enterprises acquired three different pieces of furniture and equipment for its newly renovated office. The bulk purchase from Wonder Technologies, Inc.included the following assets and corresp..
Analyze the adjusted present value methodology : Analyze the adjusted present value (APV) methodology and make at least one recommendation for improvement. Explain your rationale. Create 2 to 3 best practices that any multinational corporation could apply to multinational cash management.
Pipe flow velocities and hydraulic grade lines : ASSIGNMENT - Determine the pipe flow velocities and hydraulic grade lines (HGLs) at the nodes throughout the network for three distinct stages of development. (From a village to a major city.)
Journalize the entry to record the issuance of bonds : On April 1, 2014, Webber Corporation issued $6,500,000 of 10-year, 11% bonds at a market (effective) interest rate of 8%, receiving cash of $7,825,055. Interest is payable semiannually on April 1 and October 1. Journalize the entry to record the issu..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  If an electromagnetic wave described by the te20 mode

If an electromagnetic wave described by the TE20 mode is excited and is propagating down the waveguide, what happens to the electromagnetic wave described by the TE10 mode?

  Design a logic probe that indicates the logic state of node

Design a Logic Probe that indicates the logic state of a node of any TTL circuit using two LEDs (a red one, and a green one). The probe must work with the same power of the circuit that you want to analyze: same Vcc and same GND.

  Explain an electric heater is connected to a constant

The Problem: An Electric Heater is connected to a constant 250-V source and absorbs 1000 W. Subsequently, this heater is connected to a constant 210 V source.

  Find the code word transmitted for the data word

a) Find the code word transmitted when the data word is 101100011011. b) Draw the LFSR circuit to generate the CRC. Generate the CRC by applying the data pattern to the LFSR and verify the answer in part a.

  Design sequence generator circuit with 4 outputs w-x-y and z

Design a sequence generator circuit with 4 outputs W,X,Y and Z. The circuit should generate the following sequence of output patterns: 0001, 0011, 1100, 1000. After 1000, the circuit should repeat the sequence starting at 0001 again.

  What are difference between ra 9292 and ra 5734

What are difference between ra 9292 and ra 5734?kindly help me with my assignment.

  Determine the value of r

Problem 1: In the figure shown, each resistor has the same resistance R. The equivalent resistance measured between terminals A and B is Req = 38 Ohms. Determine the value of R.

  Compute the volume of the discharged water per second

A hydroelectric dam has a penstock that discharges 10^5 kg/s of water. The head of the dam is 80m. a. compute the volume of the discharged water per second (flow rate). b. compute the power of the water entering the turbine

  Which of the following relative pathname is interpreted as

which of the following relative pathname is interpreted as the rock.htm file is in the same folder as the current

  Sketch roughly the amplitude response of the filters

pole-zero configurations of certain filters are shown in Fig.P5.6-1(Linear Systems and Signals (2nd) by Author: B. P. Lathi). Sketch roughly the amplitude response of these filters.

  Calculate vzo and rlimit to keep zener power dissipation low

Voltage regulator utilizes a 500 mW Zener diode with Vz=6.7V at 20mA, rz=lOohm and IzK=5mA. The supply voltage y+ has a nominal value of 12V but can vary by ± 1 V. The load resistor is fixed at 330ohm

  Find the rate of heat transfer to the air conditioner

The air conditioner in a house or a car has a cooler that brings atmospheric air from 30 degree c to 10 degree c both states at 101 kPa. if the flow rate is 0.5 kg/s find the rate of heat transfer.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd