Calculate the retardation coefficient for the three chemical

Assignment Help Civil Engineering
Reference no: EM13316866

Groundwater has been contaminated with three chemicals: benzene (log Kow 2.13), pentachlorobenzene (log Kow 5.03), and naphthalene (log Kow 3.36). The aquifer (rs = 2.3 g/cm3; h = 0.4; foc = 0.02) has a gradient of 0.004 and hydraulic conductivity of 500 m/day.

a. Which chemical will be transported the farthest downgradient? Draw an overhead snapshot (planar view) of the plume(s) at a representative time.

b. Calculate the retardation coefficient for the three chemicals.

c. Find the Darcy velocity and the average linear groundwater velocity.

d. Ignoring dispersion and the other chemicals, how long will it take the benzene plume to reach a drinking water well 1000 m downgradient?

e. Given an initial benzene concentration of 20 ?g/L and degradation constant in the aquifer of 0.25 yr-1, assess the lifetime cancer risk to an adult of drinking 2 L/day of benzene-contaminated well water for 30 yrs. Assume residential setting

Reference no: EM13316866

Questions Cloud

What is the concentration of hypochlorite ion in mg per l : If 5 mg of NaOCl are added to one liter of water and the pH is measured to be 7.8, what is the concentration of hypochlorite ion (OCl-) in mg/L
How much work must be done to stretch the spring : A spring with spring constant of 29 N/m is stretched 0.21 m from its equilibrium position. How much work must be done to stretch it
Determine the carburizing time necessary to achieve : Determine the carburizing time necessary to achieve a carbon concentration of 0.35 wt% at a position 2 mm into an iron-carbon alloy that initially contains 0.10 wt% C.
Determine the mass flow rate of the cooling water : refrigerant 134a is compressed at steady state from 2.4 bar, 0 degrees celcius, to 12 bar, 50 degrees celcius. Refrigerant enters the compressor with a volumetric flow rate of 0.38m^3/min, and the power input to the compressor is 2.6 kW.
Calculate the retardation coefficient for the three chemical : Groundwater has been contaminated with three chemicals: benzene (log Kow 2.13), pentachlorobenzene (log Kow 5.03), and naphthalene (log Kow 3.36). The aquifer (rs = 2.3 g/cm3; h = 0.4; foc = 0.02) has a gradient of 0.004 and hydraulic conductivity..
What is the max height of the rocket : A rocket is launched from rest with an acceleration of 30m/s^2 for the duration of one second when it runs out of fuel. What is the max height of the rocket
Calculate the hydraulic conductivity k of the soil sample : The diameter of the sample and the standpipe were 9.8 cm and 0.75 cm, respectively. The water level in the standpipe was observed to fall from 60 cm to 45 cm in 12 minutes. Calculate: a. The hydraulic conductivity k of the soil sample .
What is the change in temperature of the brake pads : A 804 kg car is going 20 m/s and the driver has to slam on his brakes to prevent an accident. what is the change in temperature of the brake pads
What is loss in truck operating cost for the logging company : The performance functions of these three routes are: t1=50+0.2v1, t2=80+0.1v2, t3=120 + 0.05v3 t1, t2, t3 and are travel times in minutes; v1, v2, v3 are flows in number of trucks per day.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Hydraulic behaviour in open channel

Describe how test flumes and associated equipment are used to assess and confirm hydraulic behaviour in open channel

  How much would the temperature in the garage increase

A garage (24 ft x 24 ft x 10 ft) is illuminated by (6) 60 watt incandescent bulbs. It is estimated that 90% of the energy to an incandescent bulb is dissipated as heat. If the bulbs are left on for 3 hours, how much would the temperature in the ga..

  At what equal height above shorline should target be located

A surveyor is going to take a 5.5 mile sight across a lake from the top of one tower to a target on the top of another tower. It is desired to keep the line of sight 6 ft above the lake surface.

  Determine how many combinations of 2 books can be selected

A customer randomly select 2 of 10 books to purchase. How many combinations of 2 books can be selected

  Determine which equation is valid in any system units

According to information found in an old hydraulies book, the energy loss per unit weight of fluid flowing through a nozzle connected to a hose can be estimated by the formula h=(0.04 to 0.09)(D/d)^4*V^2/2*g

  Estimate the volume of recharge during the rainy season

A volume of 1.5x106 m3 of water is then pumped out of the aquifer resulting in a decrease of the groundwater level to 208.8 m. Assuming that the water table in the aquifer responds similarly

  Design a shore river intake system in a cold climate

Provide the minimum number of ports. The design conditions are: Winter design fl ow rate  4,300 m 3 /d Minimum river elevation held constant by lock and dam system  99.0 m 500-year fl ood elevation  113.3 m River bottom elevation  90.4 m

  Calculate the pressure drop to process pregelatinized starch

A single screw extruder is being used to process pregelatinized starch. The screw dimensions are as follows: channel width 3 cm, channel height 0.5 cm and screw length 50 cm. The wall velocity is estimated to be 0.31 m/s.

  Determine the horizontal and vertical components of reaction

Determine the horizontal and vertical components of reaction at the pin supports at A and B and indicate direction. Take F1 = 7 KN, F2 = 6 KN, and h = 1 m.

  Determine the values of theta dot and theta dot at instant

The plate OAB forms an equilateral triangle which rotates counterclockwise with increasing speed about point O. If the normal and tangential components of acceleration of the centroid C

  Evaluate the acceleration along and normal to the path

The velocity along a pathline is given by V (m/s) = s^2 x t^(1/2) where s is in meters and t is in seconds. The radius of curvature is 0.5 m. Evaluate the acceleration along and normal to the path at s = 2m and t = 0.5 seconds.

  Determine what should be the magnitude of the load p2

A second load P2 is uniformly distributed around the cap plate at B. The diameters and thicknesses of the upper and lower parts of the post are dAB= 1.25 in, tAB= 0.5 in, dBC= 2.25 in and tBC= .375 in respectively.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd