Calculate the quantity of heat transferred to the water

Assignment Help Civil Engineering
Reference no: EM13307773

Water is used in a heat exchange to cool 5 kg/s of air from 400 C to 200 C. Calculate (a) the minimum mass flux (kg/s) of the water and (b) the quantity of heat transferred (MJ) to the water each second. The water enters at 20 C and leave at 30 C.

Reference no: EM13307773

Questions Cloud

What would be the fraction of trucks entering the section : Consider a highway section where traffic is stationary, all trucks travel at speed s and cars at speed v. If aerial surveillance revealed that trucks were a fraction p of the vehicles on a photograph
Compute how thick is the oil : An oil layer floats on 85 cm of water in a tank. The absolute pressure at the bottom of the tank is 112.0 kPa. How thick is the oil
Weighted scoring model depicted : Read the “Weighting Systems” section of chapter 9 in the PMP Exam Study Guide textbook (which references the Weighted Scoring Model depicted in Chapter 2) and respond to the following: It is a common practice for companies to create a proposal evalua..
What is the power rating on the convection : A strong wind current of 9.1 m/s is carrying gas a distance of 27351 m. What is the power rating on the convection
Calculate the quantity of heat transferred to the water : Water is used in a heat exchange to cool 5 kg/s of air from 400 C to 200 C. Calculate (a) the minimum mass flux (kg/s) of the water and (b) the quantity of heat transferred (MJ) to the water each second.
Health care workforce issues : Write a 700 words document  paper minimum indicating what policies and procedures you would include in a public health agency or health care organization's employee handbook. Briefly describe what policies, procedures, laws and work rules you feel ar..
How much energy is needed to complete this process : 44.3 kg of ice is melted into water then raised to a temperture of 354.8 K. How much energy is needed to complete this process
Find the gravitational field and gravitational potential : Two point particles with masses m and 4m are placed along the x-axis at x = - a, Calculate the gravitational field and gravitational potential at x = 0
Determine the inlet and exit tempertures and exit quality : A steady flow of refrigerant 134a enters a throttling valve in a refrigeration unit as a satrurated liquid with a pressure of 150 psia. The refrigerant is discharged with a pressure of 40 psia.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What are the main policy aspects of the clean water act

What are the major policy aspects of the Clean Water Act? What is the history and statutory basis for federal regulation of wetlands? What are the national permits? What are the origin and significance of the no net loss policy?

  Calculate the mass of ammonium added to 1 l of water

Ammonium (NH4+) is a weak acid with a pKa of 9.26. The dissociation is: NH+4 NH3 + H+. Calculate the mass of ammonium added to 1 L of water in order to obtain a pH of 4 at equilibrium.

  Find compression of spring when car is momentarily bought

if the rolling resistance is 1/100 of the weight of the car, determine the compression of each spring when the car is momentarily brought to rest spring 1 500kN/m spring 2 300kN/m and distance between springs and car 30m

  Determine the required slab thickness of subgrade reaction

the reliability is to be 95%, the overall standard deviation is 0.4, the drainage coefficient is 0.9, delta PSI is 1.7 ( with TSI of 2.5), and the load transfer coefficient is 3.2. the modulus of subgrade reaction is 200 lb/in^3.

  How much of a reduction in the automobile emission

How much of a reduction in the automobile emission rate would be required to achieve the maximum eight-hour average NAAQS for CO at steady state 9ppmv (10.3 mg/m3)?

  Determine the maximum velocity that the skier will achieve

A person with a mass of 200kg wearing snow skis is gliding down a long slope at an angle of 20 degrees. Each ski is 200cm long and 5 cm wide. The pressure of the skis on the snow melts a thin layer of water so that a

  Determine the magnitude of the acceleration of point p

A wheel has an angular acceleration of alpha=(0.5*theta) rad/s^2 , where theta is in radians. a) Determine the magnitude of the velocity of point P located on its rim after the wheel has rotated 2 revolutions.

  Determine the horizontal reaction

a gate having cross section shown in fig closes an opening 5 ft and 4 ft high in a water reservoir. The gate weighs 400lb and its center of gravity is 1 ft to the left of AC and 2 ft above BC. Determine the horizontal reaction that is developed on..

  Determine the support reactions at a and e of the truss

A 2,000 lb uniformly-weighted crate is attached by light, inextensible cables to the truss. Simply determine the support reactions at A and E of the truss

  Calculate individual standard deviations for treatment group

One issue is to calculate the "pooled" variance and "pooled" standard deviation. Since we expect that the variances of the improvement scores by both groups could be a bit different, we'd want an overall value that reflects the variance of both gr..

  Falling-head permeability test

A falling-head permeability test was carried out on a clay soil of diameter 100 mm and length 150 mm. In 4 minutes the head in the standpipe of diameter 5mm dropped from 680 to 350 mm.

  What is the ph of the solution

What is the pH of the solution created by combining 0.90 mL of the 0.10 M NaOH(aq) with 8.00 mL of the 0.10 M HCl(aq)? with 8.00 mL of the 0.10 M HC2H3O2(aq)?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd