Calculate the probability that the magnitude of the voltage

Assignment Help Electrical Engineering
Reference no: EM13226393

A noise voltage observed at the output of a receiving antenna can be considered as a Gaussian random variable with mean 0 and variance 10*^(-8)

(a) Calculate the probability that the magnitude of this voltage is between 4 *10^(-4) and 6 *10^(-4) ?

(b) This voltage is measured using a defective voltmeter, which always indicates a lower reading than the actual value. Suppose the voltmeter reading is 2.5*10^(-4). Calculate the probability that the error is not more than 0.5 *10^(-4).

Reference no: EM13226393

Questions Cloud

Explain what will the pressure in the ball : A football is inflated to a pressure of 1.00 x 10^3 torr in a room at 25 degrees C. If the game is played at 10 degrees C, what will the pressure in the ball be, neglecting any volume change in the ball and assuming that it doesn't leak?
Explain what is the maximum pressure the tank achieves : the MWP for a tank is 207.0 bar at 20 degrees C. If the tank is filled at 200.0 bar at 20 degrees C, what is the maximum pressure the tank achieves if left in the sun on a boat, if the tank temperature reaches 35.0 degrees C?
Explain what will be the volume of air in lungs : Assuming the diver took a deep breath (6.0L in her lungs)at 1.0 atm just before entering the water, what will be the volume of air in her lungs when she gets to 10 feet of depth? She does not exhale while descending.
What are the importance of projects and project management : What are the importance of projects and project management to an organization?
Calculate the probability that the magnitude of the voltage : (b) This voltage is measured using a defective voltmeter, which always indicates a lower reading than the actual value. Suppose the voltmeter reading is 2.5*10^(-4). Calculate the probability that the error is not more than 0.5 *10^(-4).
Write a one to two page-paper describing options for resolve : Write a one to two page-paper describing options for resolving this issue. Support your answer with evidence from references.
Draw the initiation step and one propagation step : Draw the initiation step, one propagation step, and the disproportionation-termination step for the chain-growth polymerization of vinylidene difluoride (1,1-difluoroethene).
Determine the range of demand probabilities : What is the decision to be made, what is the chance event and what is the consequence for this problem? How many outcomes are there for the chance event?
Identify sources of risk for each member of buying center : Assume that you make scanners and this situation is pretty typical of what you would find. How would this information influence your marketing activities? Be as specific as possible.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Generating multivariate random variables

Generate a new random variable X with pdf fX. Specifically, we want to generate a Gaussian random variable and relationship between Rayleigh and Gaussian distributions.

  Explain current pulses over a twisted pair telephone line

Current Pulses over a Twisted Pair Telephone Line, A twisted pair telephone line has a constant attenuation between 0 Hz and 3300 Hz and linear phase shift with frequency

  Explain the significance of these intersections

construct a vertical line on your I versus V graph at the point V=5V. this line will intersect each of the sloping lines at two separate points. explain the significance of these intersections.

  Calculate the first two energy levels

A one-dimensional infinite potential well with a width of 12 Ao contains an electron. (a) Calculate the first two energy levels that the electron may occupy. (b) If an electron drops from the second energy level to the first, what is the wavelengt..

  Determine the signal/noise ratio

Determine the signal/noise ratio (Eb/No) in input of the receiver for each modulation format presented below if symbol error rate (SER) is required to be 10-^4 (use the coherent detection), for the solution the appropriate graphs can be used inste..

  What then is the indicated temperature

Suppose the RTD of (108.1 Ohms) has a dissipation constant of 25mW/°C and is used in a circuit that puts 8 mA through the sensor. If the RTD (108.1 Ohms) is placed in a bath at 100°C, what resistance will the RTD have

  What value of capacitor should be put in series

You have a 10 nH inductor. What value of capacitor should you put in series with the inductor to achieve an impedance of Z=j50 ohm at f=1.0 GHz

  Explain what will the new mean and variance

Maximum Likelihood to get the above parameters i.e. u0 and var. Now from these 999 points, I take one point out (lets call it i) and add a new point (lets call it j). What will the new mean and variance be?

  Define contains basic function in matlab files

Contains basic function in MATLAB files. Write MATLAB script(s) to plot the basic signals below in two subplots. The upper subplot should be a continuous waveform (don't do g) and the lower subplot should be a discrete plot.

  Explain signal-conditioning output

An LVDT is used in an accelerometer to measure seismic-mass displacement. The LVDT and signal-conditioning output is 0.31mV/mm with +/-2cm maximum core displacement.

  Estimate the worst case variation in film thickness

A wafer 100mm in diameter is mounted in an electron-beam evaporation system in which spherical radius is 40cm. Estimate the worst case variation in film thickness between the center and edges of the wafer for an evaporated aluminium 1micro meter t..

  Model a discrete-time system

To understand di erent signal models To be able to model a discrete-time system and design simple signal processing algorithms.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd