Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An open top tank contains a layer of SAE 30 oil 0.5 m thick, a layer of water 0.7 m thick, and a layer of mercury 0.3 m thick. Calculate the pressure, and the piezometric head at the free surface, at both interfaces, and at the tank bottom. Take the elevation datum at the bottom of the tank. Graph the pressure and piezometric head in the tank as functions of elevation
Explain how the different physical characteristics and moisture content of soil lead to the different angles of repose, swell, and shrinkage factors. Explain how these factors affect excavation operations and costs.
The volume of a sphere is V=4/3pir^3. Prepare a table of volume versus radius which allows the radius to vary from 2.0 to 10.0 cm in 1 cm increments. Plot the data as a graph on log log paper showing the volume to radius relation
An existing high-way railway at-grade crossing is being redesigned as a grade seperated to improve traffic operations. the railway must remain at the same elevation. the highway is being reconstructed to travel under the railway.
The setting velocity of a particle is 0.002 m/s and the overflow rate of a settling tank is 0.008 m/s. (a) what percent of the particles does the settling tank capture. If the particles are flocculated so that thie rsettling rate is 0.05 m/s
To satisfy desige limitation it is necessary to determine the effect of the 2- kN tension in the cable on the shear tension and bending of the fixed I-beam.
A rear-wheel-drive 3000lb drag race car has a 200-inch wheel base and a center of gravity 20 inches above the pavement and 140 inches behind the front axle. The owners wish to achieve an initial acceleration from rest of 15 ft/s on a level paved s..
Calculate the force (in Kn) a punch press must exert if it is to punch out a large washer from a strip of 5-mm thick sheet steel with an ultimate shear strength of 400 MPa.
The shaft diameter is 100 mm. Calculate the largest principal stresses and maximum shear stress that will occur in the shaft.
A smooth hump is placed in the bottom of the channel. What would be the depth of flow over a 3 ft high jump. How high can the hump be made without backing flow up What would be the depth of flow over and just upstream of a 6 ft high jump
A 4.00-cm-diameter, 0.80-m long rod of aluminum 7075-T6 is subjected to an axial tensile force with a factor of safety of 1.75. The yield stress and modulus of elasticity of aluminum 7075-T6 are 500. MPa and 210. GPa, respectively.
The outside and inside diameters of 75 mm and 63 mm, respectively. A strain gauge is placed on the outside of the hollow segment of the tube to measure normal strains in the longitudinal direction. assume E=73 GPa and Poissons ration v=0.33. strai..
for this purpose replace this force by its equivalent of two forces at At Ft parallel and Fn perpendicular to the beam. Determine Ft and Fn.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd