Calculate the fraction of vocs in the exhaust

Assignment Help Civil Engineering
Reference no: EM13319049

Assume that gasoline is burned with 99% efficiency in a car engine, with 1% remaining unburned in the exhaust gases as VOCs. If the engine exhausts 16 kg of gases (MW = 30) for each kg of gasoline (MW = 100), calculate the fraction of VOCs in the exhaust.

Reference no: EM13319049

Questions Cloud

What are the different types of stress of structural element : What are the different types of stress that a structural element could be subjected to at different cases of loading
If a dealer of rare artifacts purchases a 2nd century : If a dealer of rare artifacts purchases a 2nd Century Roman Vase for $250,000 and sells it to a wealthy collector for $320,000 during a given year, how much has been added to GDP for that year? A. Nothing, because the vase was produced centuries ago...
Explain compounds from most acidic to least : Rank PhCH3, Ph2CH2, and Ph3CH in order of acidity Rank the following compounds from most acidic to least
Quantity combinations favored by each of the three partners : Larry, Curly, Moe run the only saloon in town. Larry wants to sell as many drinks as possible. Moe wants to make the largest possible profits. Using a single diagram of the saloon's demand curve and its cost curves, show the price and.
Calculate the fraction of vocs in the exhaust : Assume that gasoline is burned with 99% efficiency in a car engine, with 1% remaining unburned in the exhaust gases as VOCs. If the engine exhausts 16 kg of gases (MW = 30) for each kg of gasoline (MW = 100)
Describe what might be required from a worker : How might Andrew be supported or assisted to access and use support services and associated resources and describe what might be required from a worker when supporting Andrew according to Organisational policies, protocols and procedures?
Find the pipe friction head loss between the two points : Water flows through a pipe at 14cfs. At a point where the pipe diameter is 18in. the pressure is 30 psi; at a second point, further along the flow path and 2 ft lower than the first, the diameter is 9in. and the pressure is 18psi.
The price elasticity of demand for health care has been : The price elasticity of demand for health care has been estimated to be ?0.2. Characterize this demand as price elastic, unit price elastic, or price inelastic.
Calculate how much heat must be added in the scenario : What is the theoretical maximum amount of work that could be done by a gas in a piston expanding from 10 L to 20 L (pressure of the surrounding atmosphere is 100 KPa)

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine shear stress at each wall and max shear stress

The velocity distribution for the flow of oil (SAE 20W) at 150 degrees between two plates is given by y(y-4) mm/s, where y is measured in mm and the space between the plates is 4mm. Determine the shear stress at each wall and the maximum shear str..

  Determine the maximum external pull by the tractor

Determine the maximum rimpull of the tractor in each of the indicated gears if the efficiency is 92%. If the tractor is operated over a haul road whose slope is +2.5% with rolling resistance of 80 lb/ton

  Cylindrical pressure vessel with hemispherical ends

A cylindrical pressure vessel with hemispherical ends has a 2.5-m radius and a 5-mm wall thickness. It contains a gas with pressure pi = 6×10 5 Pa and the outer wall is subjected to atmospheric pressure p 0 = 1 × 10 5 Pa.

  How many grains of rice were placed on the 16th square

there is a legend that the inventor of chess asked fora small payment in return for the marvelous game he had developed; one grain of rice for the first square on the chess board, two for the second square, four for the third square, and so on.

  Find the strain develope in the sample

a quartzite sample in a compression testing mechine is 180mm long and 54mm in diameter. what is the stress under a load of 100kN? if the modulus of elasticity is 102kN/mm2, find the strain develope in the sample.

  Force required to maintain this motion

The viscosity of the film of oil separating the piston from the cylinder is 0.020 lb.s/ft. Calculate the force required to maintain this motion.

  What does line of collimation means

How to detect eror in line of collimation and what does line of collimation means.

  Evaluate the acceleration along and normal to the path

The velocity along a pathline is given by V (m/s) = s^2 x t^(1/2) where s is in meters and t is in seconds. The radius of curvature is 0.5 m. Evaluate the acceleration along and normal to the path at s = 2m and t = 0.5 seconds.

  Determine the force exerted by the jet on the plate

A jet of water of diameter 75mm moving with a velocity of 25m/s strikes a fixed plates in such a way that the angle between the jet and plate is 60 find the force exerted by the jet on the plate.

  Determine the speed of the impellers in rpm

The plant is to employ alum coagulation. and pertient data for the folcculation basin are as follows: detention time = 20 min, G = 35 /sec at 50F, GT = 10000 to 100000, width = 1.25 depth, length = 2width, no baffling, number of impellers = 2

  Determine the rate of heat transfer to the stock in furnace

Cylindrical, steel bar stock (density = 7833 kg/m3, Cp = 0.465 kJ/(kg C)) of 10-cm diameter is heat-treated by drawing it at a velocity of 3 m/min through a 6-m-long furnace maintained at 900C.

  Property of sanstone and of the quartzite

if you had a choice of three kinds of aggregate--a sandstone,a crushed basalt,and a quartizite,you may select the basalt.Give one possible characteristic or property of sanstone and of the quartzite that made you decide not to select it for your c..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd