Calculate the force on the levee gates form storm surge

Assignment Help Civil Engineering
Reference no: EM13326262

In a random city the weak spot of the levee system occurred at flood gates, about 25 feet in wide, 40 feet high, at the end of canals used to pump water from the city into a lake. Higher water level inside the eye, combined with wind results in a "storm surge". Calculate the force on the levee gates form storm surge 20 feet above level of the lake traveling at about 25 ft/sec.

Reference no: EM13326262

Questions Cloud

Estimate the ground- level concentration at a distance : A point source with effective stack height of 50 m emits 80 g/s of on a clear summer day with surface winds at 4 m/s. Winds at 50 m are 5 m/s. An inversion layer starts at an elevation of 250 m.
Estimate ground-level particulate concentration 40m downwind : A long line of burning agricultural waste emits 0.3 g/m/s of particulate matter on a clear fall afternoon with winds blowing 3 m/s perpendicular to the line. Estimate the ground-level particulate concentration 400 m downwind from the line.
How high above the ground is the cannonball : A cannonball is shot (from ground level) with an initial horizontal velocity of 33 m/s and an initial vertical velocity of 24 m/s. How high above the ground is the cannonball 3.3 seconds after it is shot
By how much did the energy change during the insertion : A 13.5?F capacitor is connected to a power supply that keeps a constant potential difference of 26.0V across the plates. By how much did the energy change during the insertion
Calculate the force on the levee gates form storm surge : Higher water level inside the eye, combined with wind results in a "storm surge". Calculate the force on the levee gates form storm surge 20 feet above level of the lake traveling at about 25 ft/sec.
Find the permittivity of polystyrene : A capacitor has parallel plates of area 12 cm2 separated by 2.0mm . The space between the plates is filled with polystyrene (K=2.6, Em=2.0×107V/m). Find the permittivity of polystyrene
Specify and construct the foundations for the new building : The subsoil at the site is a thick layer of soft alluvial river silts and sands, the bearing capacity of the silt has been found to be in the region of 80 kN/m2. There is a high ground water table present.
What is the value of electrical energy produced : If you have 1.96 * 10^9 KWH and the value of energy is $0.10 per KWh, what is the value of electrical energy produced
Calculate the magnitude of the electric field in dielectriv : A parallel-plate capacitor has the volume between its plates filled with plastic with dielectric constant K. Use Gauss's law to calculate the magnitude of the electric field in the dielectric

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the corresponding amplitude of the acceleration

calculate the amplitude F0 of the sinusoidal excitation force that is necessary to produce a steady-state vibration with a velocity amplitude of 10 m/s at resonance. what is the corresponding amplitude of the acceleration

  What is the static pressure of the water at the outlet

A PVC pipe has an inside diameter of 40 mm, is 30 m long and carries 10°C water at a rate of 3.5 m3/hr. At this rate, the friction factor of the pipe is 0.0814.

  Find probability at least one inquiry is made during the sec

The number of teleport inquires x in a time sharing system average .2 millisecond and follows a Poisson distribution. Find the probability at least one inquiry is made during the next millisecond.

  Determine height from ground where the two balls pass

One second later another ball is thrown vertically from the ground with a velocity of 10m/s. Determine the height from the ground where the two balls pass eachother.

  What is the maximum height the pump can be installed

A particular mixed flow pump is operating just below the point of cavitation. The pump is sited with its intake 3 m above the water level in the reservoir and delivers 0.05 m3/s.

  Falling-head permeability test

A falling-head permeability test was carried out on a clay soil of diameter 100 mm and length 150 mm. In 4 minutes the head in the standpipe of diameter 5mm dropped from 680 to 350 mm.

  Engineering ethics and ethical issue

what is the engineering ethics course where to write about any engineering ethical case and discuss the ethical issue?

  Write an equation on the line containing the given point

Write an equation on the line containing the given point and parallel given line. Express answer in the form y=mx+b (3,7) x+6y=5

  Calculate the location of the effective depth on both sides

beam is 24 inch deep, the steel stirrup used is number 4,a 1 1/2 inch. concrete cover on both sides. Sketch how you will place the bars and calculate the location of the effective depth.

  Determine the rate of return that the company will make

Five years ago, GSI, an oil services company headquartered in Texas, issued $10 million worth of 12% 30-year bond with the dividend payable quarterly. The bonds have a call date of this year if GSI decides to take advantage of it.

  Find the rate of change of temperature measured by the probe

a temperature probe moves with the velocity 2i+2j-3k through air. the temperature of air changes as T(x,y,z,t)=(2x^2-3y+z^3)cos(at). Find the rate of change of temperature measured by the probe.

  Find required size of new schedule 40 steel pipe to carry

Determine the required size of new Schedule 40 steel pipe to carry 0.5 cfs (Q = 0.5 cfs) of water at 160o F with a maximum pressure drop of 10 psi per 1,000 ft.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd