Calculate the elastic recovery

Assignment Help Civil Engineering
Reference no: EM13210563

A 10-mm diameter bar of 1040 carbon steel is subjected to a tensile load of 50,000 N, taking it beyond its yield point. Calculate the elastic recovery (or strain) that would occur upon removal of the tensile load. Given: elastic modulus of steel is 200 GPa, yield and ultimate tensile strength of steel are 600 and 750 MPa, respectively.

Reference no: EM13210563

Questions Cloud

Explain quick way to detect the presence of bromine chlorine : method would be a quick way to detect the presence of bromine/chlorine?
Determine the force in chains ac and ad during the lift : the 3.5mg engine is suspended from a 500 kg spreader beam and hoisted by a crane which gives it an acceleration of 4m/s^2 when it has a velocity of 2m/s. determine the force in chains AC and AD during the lift.
Replace the two couples with a single equivalent couple : The two shafts in a speed-reducer unit are subjected to couples of magnitude M1 = 18 N · m and M2 = 7.5 N · m, respectively. Replace the two couples with a single equivalent couple, specifying its magnitude and the direction of its axis.
Find the force that these gas generates on the top : the circular top of a can has a radius of .0320m. the pull-tab has an area of 3.8x10^-4 m^2. the absolute pressure of the carbon dioxide in the can is 1.40x10^5Pa. find the force that these gas generates on the top of a can?
Calculate the elastic recovery : A 10-mm diameter bar of 1040 carbon steel is subjected to a tensile load of 50,000 N, taking it beyond its yield point. Calculate the elastic recovery (or strain) that would occur upon removal of the tensile load.
State allows fireflies to illuminate the abdomens : Firefly luciferase is the enzyme that allows fireflies to illuminate their abdomens. Because this light generation is an ATP-requiring reaction, firefly luciferase can be used to test for the presence of ATP
Find the dimensions of an acceptable box of a largest area : a delivery company accepts only rectangular boxes the sum of whose length and girth (perimeter of a cross section) are equal to 108cm. find the dimensions of an acceptable box of a largest area.
Why do many managers act like control freaks : What does it have to do with control? Why do many managers act like control freaks? Why do many managers micromanage so much? Why are many managers reluctant to take the actions necessary to correct deviations?
Determine the value of po : determine the value of Po, as a funciton of H, for these two investment alternatives to be equivalent at an interest rate of i=15% per year.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Formulate a linear program for blend mix

Formulate a Linear Program for Blend Mix at Bluegrass Distillery, The Bluegrass Distillery produces custom-blended whiskey

  Derive the expression for reversible work

What is work? Why is it path dependant? Derive the expression for reversible work from a closed system containing a simple compressible substance.

  Find the conductive heat loss through the furnace wall

Assuming unit surface area, find the conductive heat loss through the furnace wall and the temperature at the interface of the fire clay and red brick.

  Pressure on the soil if theta is given

A pipe is to be installed under the ground on a bed of aggregate 6 in. thick. The entire weight on the aggregate from pipe and soil above the pipe is 1800 lbs. per linear foot of pipe. What is the pressure on the soil if theta is 45 degrees? Assum..

  Overall gear reduction ratio

If the overall gear reduction ratio is 8 to 1, what is the maximum acceleration from rest (in ft/sec^2) for: a) the car with the base engine? b) car with the modified engine? Assume the car is on good dry pavement.

  Determining specific gravity

The cross sectional dimensions of a 4-ft-long wood member at 30% moisture content is 1.5 in. x 7.5 in., and its weight is 11 lb. At oven-dry condition, its dimensions and weight are 1.35 in x 6.8 in., and 10.2, respectively. What is its specific g..

  Water behind the three gorges dam

Could all the people in china hold back the water behind the three gorges dam?

  Determine which motor should be installed based on the pw

At the end of 15 years, the first motor will have a salvage value of $50 and the second motor will have a salvage value of $100. consider the MARR to be 8%. (note : 1HP=0.7457 kw). Determine which motor should be installed based on the PW criterio..

  Ultimate bod of municipal wastewater-reaction rate constant

If bod5 and ultimate bod of a municipal wastewater are 200mg/l and 457 mg/l respectively what is the reaction rate constant? a) .265 b) .050 c) .115 d) .165

  Coefficient of static friction between pacakges

The belt starts from rest at time t=0 and its speed increases at a constant rate of 150mm/s^2. Knowing that the coefficient of static friction between the pacakges..

  Elevation and stationing of the low point

A 1600 ft long sag verical curve (equal tangent) has a pvc at station 1200+00 and elevation o 1500 ft. the initial grade is -3.5% and the final grade is 6.5%. determine the elevation and stationing of the low point, pvi and pvt.

  Highest point of the piping system

a) The maximum flow rate that can be achieved without cavitation occurring in the piping system. b) The maximum elevation of the highest point of the piping system to avoid cavitation.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd