Calculate product temperature at the center

Assignment Help Mechanical Engineering
Reference no: EM13710336

A cooked mashed potato is cooled on trays in a chilling unit with refrigerated air at 2 C blown over the product surface at high velocity. The depth pf the product is 30mm and the initial temperature is 95 C. The product has a thermal conductivity of 0.37 W/ (m K), specific heat of 3.7 kJ/kg K and density of 100 kg/m^3. Assuming negligible resistance to heat transfer at the surface, calculate product temperature at the center after 30 min.

Reference no: EM13710336

Questions Cloud

Determine the radius of curvature of the particle path : A particle which movies in a two-dimensional curvilinear motion has coordinates in millimetres which vary with time t in seconds according to x=5t2 +4 and y=2t3 + 6. For time t =3s, determine the radius of curvature of the particle path and the magni..
Neglect kinetic-potential energy changes-compressor power : Air is compressed at steady state from 100 kPa, 300 K, to 600 kPa, 440 K with a mass flow rate of 4 kg/s. Heat transfer occurs at a rate of 42.3 kJ/kg of air flowing to cooling water circulating in a water jacket enclosing the compressor.
What is the mass flow rate of gaseous oxygen : Liquid oxygen (LOX) is used as rocket fuel to launch satellites into space. However, it is easier (and less dangerous) to transport oxygen in gaseous form. What is the mass flow rate of gaseous oxygen that flows at 25 m/s through a 0.5-meter diameter..
Neglecting heat transfer and potential energy : Steam enters a nozzle at steady state at 20 bar and 280°C, with a velocity of 80 m/s. The exit pressure and temperature are 7 bar and 180°C. Mass flow rate is 1.5 kg/s. Neglecting heat transfer and potential energy. Sketch the process on a T-v diagra..
Calculate product temperature at the center : A cooked mashed potato is cooled on trays in a chilling unit with refrigerated air at 2 C blown over the product surface at high velocity. The depth pf the product is 30mm and the initial temperature is 95 C. The product has a thermal conductivity of..
Allows the user to enter number that represent month of year : Write a program that allows the user to enter a number that represent the month of a year (1 to 12) and uses a switch construct to convert the month number to its corresponding number of days, where January is considered the 1st month of a year and D..
What is the amount of the equal monthly payment : Suppose you take out a car loan of $10,000 with an interest rate of 12% compounded monthly. You will pay off the loan in 48 months with equal monthly payments. What is the monthly interest rate? What is the amount of the equal monthly payment?
Take for the buyer to completely pay for the building : A building is priced at $255,000. If a buyer makes a down payment of $55,000 and a payment of $2,000 every month thereafter, how many months will it take for the buyer to completely pay for the building? Interest is charged at a rate of 9% compounded..
What is the displacement of the spring : The cable segment attached to the spring is at an angle of ?=50.0 from the ground. The spring has a spring constant of k=14.5 kN/m. The pulley is attached to the ceiling by rod BD that forms an angle ?=70.0? with the ceiling. The hanging mass causes ..

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Ateam at 5 bar 320 c enters a steady state turbine with a

ateam at 5 bar 320 c enters a steady state turbine with a volumetric flow rate of 0.65m3s and evpands adiabatically to

  The isentropic efficiencies for the turbine and pump are 85

a cycle based on a rankine cycle with water as the work fluid must have its highest cycle pressure and temperature at

  Air is at 20 degree c and has a free stream velocity of u

a thin-flat plate having a length of l 10 cm is heated by a constant-heat flux from the bottom and cooled by an air

  Noting that a person standing in a room maintained at

noting that a person standing in a room maintained at 20degc at all times the inner surfaces of the walls floors and

  Determine the maximum normal stress

Determine the maximum normal stress in a 300-mm diameter basketball that has a 2-mm wall thickness after it has been inflated to a pressure of.

  Determine the minimum tensile strength each cable must have

due to a poorly designed foundation the statue at point a slowly slides down a grass covered slope. to prevent further

  Explain turbine of an ideal rankine cycle with reheat

Steam @ 10 MPa, 600 degrees celcius enters the first-stage turbine of an ideal Rankine cycle with reheat. The steam leaving the reheat section of the steam generator is @ 500 degrees celcius

  Calculate the bulk density of a rock which has 20 porosity

calculate the bulk density of a rock which has 20 porosity. the bulk mineralogy of the rock is 80 quartz 15 calcite and

  Plot the final temperature against the initial pressure

An insulated tank is divided into two parts by a partition. One part of the tank contains 2.5 kg of compressed liquid water at 60°C and 600 kPa while the other part is evacuated. The partition is now removed, and the water expands to fill the entire ..

  If the turbine dissipates heat to its surroundings at the

a turbine operates at steady state with steam flowing through it at a rate of 36 kgmin. the steam enters the turbine at

  An adiabatic piston-cylinder system contains a 1000-w

an adiabatic piston-cylinder system contains a 1000-w immersion heater and 4kg of h2o initially at 1 atm and 96 percent

  If the process occurs slowly enough that the temperature in

atank of 0.1-m3volume contains air at 298.15k 25degc and 101.33kpa.the tank is connected to a compressed-air line which

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd