Calculate primary consolidation settlement for the ch layer

Assignment Help Civil Engineering
Reference no: EM13318318

Consider the soil stratigraphy . The groundwater table drops by 4.5 m as a result of a dewatering project. The unit weight of the dewatered CL layer is 12 kN/m3. Calculate the primary consolidation settlement for the CH layer, assuming that it is normally consolidated with a water content of 70% and a compression index of 0.25.

Reference no: EM13318318

Questions Cloud

What are some challenges to traditional policing : What are some challenges to traditional policing? How might some of these challenges be related to gender and race issues? How do these challenges increase stress and burnout in law enforcement?
Analyze the overlap graphs of the voice packet : Analyze the overlap graphs of the Voice Packet End-to-End Delay and Voice Packet Delay Variation graphs. Compare the three queuing disciplines and explain their effect on the performance of the three applications.
Evaluate the ph of the solution formed by the addition : Calculate the pH of the solution formed by the addition of 55.5 mL of 0.100 M NaOH to 49.2 mL of 0.100 M H3PO4.
Determine how much work is done : A force of 15 N acting at an angle of 25 degrees to the horizontal is used to pull a box a distance of 5 m across a floor. How much work is done
Calculate primary consolidation settlement for the ch layer : Calculate the primary consolidation settlement for the CH layer, assuming that it is normally consolidated with a water content of 70% and a compression index of 0.25.
Cases relate to the valuation of assets : Cases relate to the valuation of assets
What acceleration does the wagon have : A boy pulls with a force of 20 N on the 300 N wagon. What acceleration does the wagon have
Explain what is the maximum number of moles a gas : A 3.00L container is rated to hold gas at a pressure no greater than 100atm. Assuming the gas law behaves ideally, what is the maximum number of moles a gas that this vessel can hold at 27 degrees C
Calculate the maximum bending stress produced in the pole : A Timber power-line pole is 10 in. in diameter at its base where it is solidly embedded in concrete. The pole extends 20 ft vertically upward from its base and is subjected to a horizontal pull of 300 lb at its top.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Explain how to estimate the diameter of the small pipe

Fluid flows steadily, at a volume rate Q, through a large pipe and then divides into two small pipes, the larger of which has an inside diameter of 25 mm and carries three times the flow of the smaller pipe.

  Determine what is the change in volume of the cylinder

A piston-cylinder device contains 0.85 kg R-134a at 263K. The piston is free to move and has a mass of 12 kg and diameter of 25 cm. The atmospheric pressure is 98 kPa. Heat is added to the cylinder until the R-134 temperature = 10 o C.

  Explain how to present the geological profile of the terrain

Based on information provided in the survey bulletins and knowing that the landfill is located in the municipality of Duque de Caxias, on the shore of Guanabara Bay opposite Governor's Island (Galeao Airport)

  Determine the acceleration of each plate with a force

The coefficients of static and kinetic friction are 0.3 and 0.2, respectively, between each of the plates and between plate A and the ground. Determine the acceleration of each plate.

  How long must radioisotope be held to meet allowable charge

A hospital waste containing 0.7µCi/L of 32P is to be disposed of. How long must the radioisotope be held to meet the allowable discharge activity

  How fast will the car be traveling when it reaches the tree

a car is traveling at sea level at 78 mi/h on a 4% upgrade before the driver sees a fallen tree in the roadway 150 feet away. the coefficient of road adhesion is 0.8. The car weighs 2700 lbs, has a drag coefficiant of 0.35, a frontal area of 18 ft..

  Estimate the density of the air at an elevation of 10 km

Titan, a moon of Saturn, is believed by astronomers to have an atmosphere that is about 95% nitrogen. At Titan's surface the acceleration due to gravity is 1.35 m/s2, the atmospheric pressure is 210 kPa, and the temperature is 94 K.

  What is level of service of compound-grade freeway segment

The directional hourly traffic flow is 2000 vehicles with 5% large trucks and buses (no recreational vehicles). The total ramp density for this freeway segment is 2.33 ramps per mile. If peak hour factor is .90

  Explain why not use rubber to seal wine bottles

Cork is used for sealing sparkling wine bottles. Aside from friction, why not use rubberbto seal wine bottles. (Hint: think about the force exerted by the pressure inside and how does that deform each material) Be sure to use poissons ratio in the..

  Calculate distance downwind xl at which the plume released

A powerplant is burning coal on a cold, clear winter morning at 8am with a wind speed of 2.6m/s measure at 30m and an inversion layer with its base height of 697m. The effective stack height is 30m.

  Determine the horizontal reaction

Determine the horizontal reaction that is developed on the gate at C.

  Define concentration of pollutant in the effluent leaving

A lagoon with volume 1200 m^3 has been receiving a steady flow of a conservative waste at a rate of 100m^3/day for a long enough time to assume that steady-state conditions apply

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd