Calculate ground-level concentration downwind and crosswind

Assignment Help Civil Engineering
Reference no: EM13306470

At noon on a sunny summer day with a surface wind speed of 4m/s, SO2 is released over rough terrain from a 90m stack at a rate of 400g/s. Assume that the plume rise is 60m. Calculate the ground-level concentration: (a) 3000m downwind; (b) 3000m downwind and 100m crosswind; and 3000m downwind and 500m crosswind.

Reference no: EM13306470

Questions Cloud

How large is the resultant magnetic field : a proton is rotating in a 7.19 * 10^ -11 m radius circle with a frequency of 5 * 10 ^15 Hz, How large is the resultant magnetic field
Find infiltration rate assuming that entire crack admits air : A room in a single-story building has three 2.5 x 4 ft double-hung wood windows of average fit that are not weather-stripped. The wind is 23 mph and normal to the wall with negligible pressurization of the room.
Write a house class that has the following properties : Total number of rooms ( calculated: number of bedrooms + formal dining room if present + 1 for kitchen)Number of baths (house can have any number of 1/2 bath or 1/4 of a bath in addition to a full bath - example 1.5, 1.75 or 1.25 bath)
Money supply resulting from this transaction is equal to : Suppose that the required reserve ratio is 20 percent. A bank's customer deposits into her account $100,000.00 in funds from a check written on an account at another bank
Calculate ground-level concentration downwind and crosswind : At noon on a sunny summer day with a surface wind speed of 4m/s, SO2 is released over rough terrain from a 90m stack at a rate of 400g/s. Assume that the plume rise is 60m.
Find the temperature of the compressed air : A diesel engine works at a high compression ratio to compress air until it reaches a temperature high enough to ignite the diesel fuel. find the temperature of the compressed air
How each contributes in achieving competitive advantage : Choose any three HR activities (job analysis, recruitment and selection, training, performance appraisal, compensation) and explain how each one contributes in achieving the competitive advantage of the company.
Display both two-dimensional and one-dimensional array : For testing purposes, you may do a compile-time initialization of a 6 x 3 two-dimensional array. Display both the two-dimensional and the one-dimensional array.
Find which is less than the maximum taxable wage base : Find an equation that expresses the relationship between the wages earned (x) and the Social Security taxes paid (y) by an employee who earns less than the maximum taxable wage base.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What are the internal forces and moment at point a

Consider the two loading scenarios on the beam, where the beam is supported by a pin joint on the left and roller joint at the right end. What are the internal forces and moment at point A for each scenario

  Calculate the maximum tensile load in n

Consider a cold worked C11000 copper alloy rod 21 mm in diameter and 250 mm in length. Calculate (a) the maximum tensile load, in N, and (b) the maximum length, in mm, to which the rod may be stretched without plastic deformation.

  Question in structure analysis

Determine axial force and Max bending - Question in structure analysis

  How to determine the efficiency of the pump

Water is pumped at a rate of 1.57 cfs from one large open tank into another through a 6 in diameter cast iron pipe 400 ft long. The water level in the second tank is 160 ft above the level of the first tank and the discharge end of the pipe is sub..

  Which method would be most likely to have the conductivity

If an analysis is made of the hydraulic conductivity of a site using permeameter tests of core samples, slug tests of monitoring wells, and pumping tests of production wells, it is often observed that the hydraulic conductivity as measured by each..

  What power must pump supply to system to pump the oil

What power must the pump supply to the system to pump the oil from the lower reservoir to the upper reservoir at a rate 0.20 m^3/s. Sketch the HGL and the EGL for the system.

  Find out the number of turns in each spring

Find out the number of turns in each spring, if the diameter of the spring wire 14 mm and the diameter of coil is 80 mm. Assume C=84 GN/mmxmm.

  Highway construction project

A soil sample was taken from a proposed cut area in a highway construction project and sent to a soils laboratory for a compaction test, using the Standard Proctor compaction procedure. Results of the test are as follows:

  How to calculate the size of the truck fleet needed

An underground limestone mine with production of 12,000 tons/day will use trucks for the main haulage between an ore pass and a hoist skip pocket. The hauling distance is 5500 ft. The main haulage drift is horizontal and is 12.5 ft wide and 12.5 f..

  Purpose of the international space station

Briefly explain the purpose of the International Space Station, and list the name of all space agencies involved in building and operating it.

  What are 3 of the equivalent fixed-point problems

What are 3 of the equivalent fixed-point problems for f(x) = x2 - x -2=0?

  Calculate the discharge in each pipe and the pressure

Two reservoirs are connected with a 30" diameter pipe with a length of 19,680 ft. The water surface elevation in the upper reservoir of the upper reservoir is 984 ft, lower reservoir 886 ft and the elevation at the midpoint is 918 ft.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd