Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An interior angle x and its explement y were turned to close the horizon. Each angle was observed once direct and once reverse using the repetition method. Starting with an initial backsight setting of 0°00'00" for each angle, the readings after the first and second turnings of angle x were 49°36'24" and 99°13'00" and the readings after the first and second turnings of angle y ere 310°23'28" and 260°46' 56". Calculate each angle and the horizon misclosure.
Calculate the percentage of change in total volume with respect to its initial volume when a specimen of this clay is completely dried from a water content of 80%. Assume that the clay remains saturated from liquid limit to shrinkage limit.
what are the factors affecting the hydraulic conductivity?
Two large water reservoirs are connected by 8,000 ft of schedule 40 steel pipe. The level of one reservoir is 500 ft above the level of the other
He values the use of the pesticides at $10,000 and the neighborhood values clean air at $15,000. What does the Coase theorem suggest will take place?
Determine the maximum grade on which passenger car A can travel without its total resistance exceeding that of car B traveling on a straight and level section of road.
A roadway is to be designed on a level terrain. The roadway is 500 ft. Six Cross Sections have been selected at 0 ft, 100 ft, 200 ft, 300 ft, 400 ft, and 500 ft. . The cross sections have areas of 130 ft2, 140 ft2, 70 ft2, 110 ft2, 80 ft2, and 25 ..
Saturated liquid water is in an adiabatic compressor with inlet and outlet pressures of 100 kPa and 1 Mpa. The isentropic efficiency is 85%. Find the work input (kj/kg) and entropy generation (kj/ kg K).Do the same for saturated vapor steam in an adi..
calculate the magnitude and direction of the horizontal force exerted on the contraction (not on the water). Assume that there is no loss of energy in the contraction. Use the gamma of water is equal to 1000 kg/m^3
Water flows in a 100 m long pipe at 3 m/s. If the water temperature is 20 degrees C, determine the minimum valve-closure time to avoid creating water hammer pressures. What is the maximum water-hammer pressure that can occur
How many watts of power would it take to heat 1 L of water(weighing 1.0 kg) by 10 degrees Celsius n 1.0 h? Assume no heat losses occur, so all of the energy expneded goes into heating the water.
Perform a material balance on substrate (S) around a chemostat (completely mixed reactor without recycle) assuming a first-order removal for a substrate with a rate constant of 0.5 hr-1. The influent substrate concentration is 150 mg/L
A jet of water of diameter 75mm moving with a velocity of 25m/s strikes a fixed plates in such a way that the angle between the jet and plate is 60? find the force exerted by the jet on the plate. (a) In the direction normal to the plate and (b) In t..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd