Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A client has engaged your consultancy company to undertake a conversion of a warehouse to a residential dwelling in the northern city of Darwin. You are required to check the capacity of a proposed column to ensure it can support a mezzanine floor. Calculate the compressive capacity (N.d.c) using the Australian Standard for the following column.
- 2.4m in Height
- 150mmx75mm in cross-sectional dimensions
- F14 grade unseasoned Spotted Gum Hardwood
- The column is restrained at both ends in position and direction
- The column supports both the permenant and short term loads imposed by the floor above
- The column is restrained at half height in the minor axis direction only.
What is the average length of queue, the average time spent in the system, and the average waiting time in the queue?
A sample of natural glacial till was taken from below the groundwater table. The water content was found to be 52%. Estimate the wet density, dry density, buoyant density, porosity and void ratio. Clearly state any necessary assumptions.
Whether the wall has adequate sliding resistance and whether the wall is safe against over-turning
If bod5 and ultimate bod of a municipal wastewater are 200mg/l and 457 mg/l respectively what is the reaction rate constant? a) .265 b) .050 c) .115 d) .165
The cost of a 100,000 bbl/d ethanol unit is $40,000,000. From historical records, the capacity exponent ratio for CCR is 0.75. Estimate the cost of a similar ethanol unit with a capacity of 135,000 bbl/d.
An excavation is proposed for a site consisting of a homogenous, isotropic later of silt clay, 14.24 m thick, above a deep deposit of sand. The groundwater is 2m below ground level outside the excavation. The groundwater level inside the excavatio..
A spillway carries a discharge of 22.5 m^3/sec with the outlet velocity of 15 m/sec at a depth of 0.2m. Select an adequate USBR stilling basin and determine the sequent depth, the length of the hydraulic jump and energy loss.
The transportation agency would like to determine the maximum spacing of stations to allow trains to arrive no more than 5 minutes apart. 1. Draw a time-space diagram depicting the above scenario
The barrel has an inner diameter of 4ft. Neglect its wall thickness. Assume that only the hoops resist the water pressure. Note: Water develops pressure in the barrel according to Pascal's Law, p=62.4 lb/ft^2, where z is the depth from the surface..
An industry discharges PCE (tetrachloroethene, tetratchloroethylene, or perchloroethylene) into a small, well-mixed lake. The influent concentration is 0.4mg/L and the hydraulic residence time of the lake is 5days.
The coefficient of friction between the crate and the floor is µs = 0.4 and µk = 0.3. If P is slowly increased until the crate starts to move and then remains constant, determine using energy methods the speed of the crate after moving 2 m.
Select the number and size of reinforcing bars required to resist a total factored moment of 180 ft. kips for a rectangular section with b = 12 in., d = 19.5 in., h = 24 in., fc = 4 ksi, and fy = 60 ksi. Check for minimum reinforcement requirement..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd