Calculate by what factor the mass of propane has increased

Assignment Help Civil Engineering
Reference no: EM13296404

A typical propane tank that we use for barbeque initially contains a pressure of 10 psi. The pressure is low, so we take it to the local store to fill the tank with more propane. After filling,the pressure is 100 psi. Calculate by what factor the mass of propane has increased inside the tank? (Assume the temperature and volume are constant before and after filling the tank.)

Reference no: EM13296404

Questions Cloud

Determine specific surfaces in m2 per g units for the sphere : Determine the specific surfaces in m2/g units for the spheres of diameters (a) 10.0 cm, (b) 1.0 cm,(c) 0.1 cm, (d) 0.01 cm. (e) 0.001 cm and (f) 0.0001 cm. Assume the mass density of spheres as 2.5g/cc.
Calculate the total power supplied to the two resistors : Two resistors, 61.1 and 83.6 , are connected in parallel. The current through the 83.6 - resistor is 4.29 A. What is the total power supplied to the two resistors
Compute the maximum efficiency of the engine : Determine the changes in entropy (of the system, the surroundings, and the universe) for each step of the cycle and the cycle overall. Evaluate the maximum efficiency of the engine, assuming that the heat is supplied in step (2).
Major causes of reduced fertility rates : One of the major causes of reduced fertility rates in Canada is that women want to establish their careers prior to becoming mothers, postponing their child bearing years. In what three ways can be developed nations, such as Canada, end the current r..
Calculate by what factor the mass of propane has increased : A typical propane tank that we use for barbeque initially contains a pressure of 10 psi. The pressure is low, so we take it to the local store to fill the tank with more propane. After filling,the pressure is 100 psi.
Determine the recoil speed of the man and rifle : A rifle with a weight of 30 N fires a 6.0-g bullet with a speed of 200 m/s. find the recoil speed of the man and rifle
How much free cash flow did the firm generate during 2012 : Net income = 825; after-tax operating income 925; and Total assets = 2500. how much free cash flow did the firm generate during 2012?
Calculate the temperature of the air in fahrenheit : The "sea-level adjusted" pressure at the airport was about 30.57 inches of mercury. Assuming the density of air is 1.30 kg/m3 and the gas constant for air is 287. J/(kg K), calculate the temperature of the air in Fahrenheit.
Compute impulse is delivered to the ball by the player : A 0.329-kg volleyball approaches a player horizontally with a speed of 12.9 m/s. What impulse is delivered to the ball by the player

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  Determine the velocity and acceleration of point c of belt

determine the velocity and acceleration of point C of the belt, (a) immediately before the power is turned off. (b) 9 s later.

  Case study-disaster identifying safety management

Conduct a Case Study on this disaster identifying safety management, safety audits, accident investigation, and industrial hygiene issues. Your Case Study should be a minimum of 500 - 600 words and contain the components listed above.

  Determine the flow area

A rectangular concrete channel is 3 m wide and 2 m high. The water 20 deg Celsius in the main channel is 1.5 m deep and is flowing at a rate of 30 m^3/s. determine the flow area, wetted perimeter, and hydraulic radius. is the flow laminar or turbu..

  How much was the initial investment at an interest rate

A company that manufactures regenerative thermal oxidizers made an investment 10 years ago that is now worth $1,300,000. How much was the initial investment at an interest rate of 15% per year (a) simple interest and (b) compound interest?

  What are the factors affecting the hydraulic conductivity

what are the factors affecting the hydraulic conductivity?

  Determine the torsional moment in the hollow x-section

A concrete box girder bridge has the rectangular x-section. The box is prismatic and considered thin-walled. It span is L=48m and simply supported at points A,B,C and D. The supports are assume to be able to transfer tensile forces.

  How much force must be applied to keep the gate \

A gate (shaped like .25 of a cylinder with radius R=3m) is used to control the flow of water through a canal.The height of the water in the tank is 30m. How much force must be applied to keep the gate from opening? The gate is 30m wide.

  Determine the lubricant film thickness of flat surface area

A body weighing 120 lb with a flat surface area of 2 ft^2 slides down a lubricated inclined plane making a 30 degree with the horizontal. For a viscosity of 0.002 lb*s/ft^2 and body speed of 3 ft/s, determine the lubricant film thickness.

  Determining optimal solution

The company would like to distribute the songs between the two CDs such that the used space on each CD is about the same. Formulate the problem as an IP, and find the optimal solution.

  Determine ft and fn

for this purpose replace this force by its equivalent of two forces at At Ft parallel and Fn perpendicular to the beam. Determine Ft and Fn.

  Determine the value of gravity in units of meters

if a ball is dropped from a height of 800 cemtimeters, and the impact velocity is 41 feet per second, determine the value of gravity in units of meters per second.

  Volume of the lake

Suppose that the distance from the lake outlet to the withdrawal cannot be more than 20 mi. What should be the new volume of the lake?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd