Calculate average flow rate and hydraulic gradient

Assignment Help Civil Engineering
Reference no: EM13313484

A field sample of an aguifer is packed in a test cylinder. The cylinder has a length of 120 cm and a diameter of 12 cm. The field sample with a porosity of 0.24 is tested under a constant head difference of 160 cm with water at 10 degree Celcius. If the stimated hydraulic conductivity of the sample is 30 m/day, calculate;

Average flow rate and hydraulic gradient.

Reference no: EM13313484

Questions Cloud

What is the index of refraction of the unknown liquid : A layer of oil (n = 1.45) floats on an unknown liquid. A ray of light originates in the oil and passes into the unknown liquid. What is the index of refraction of the unknown liquid
What is the difference between syntax and semantics : Explain the distinction between an ambiguity in a proposed algorithm and an ambiguity in the representation of an algorithm.
What is the tension in the cables : A 20 Kg loudspeaker is suspended 2.0 m below the ceilling by two cables that are each 30' from vertical . What is the tension in the cables
Describe the ka of lactic acid hc3h5o3 : The Ka of lactic acid, HC3H5O3, is 1.410?4. (a) Suppose buffer #1 is prepared using 40.0 mL 0.1 M HC3H5O3 and 60.0 mL 0.1 M C3H5O3- to give a final volume of 100.0 mL. What is the pH of this buffer
Calculate average flow rate and hydraulic gradient : The cylinder has a length of 120 cm and a diameter of 12 cm. The field sample with a porosity of 0.24 is tested under a constant head difference of 160 cm with water at 10 degree Celcius.
Where do othe researchers drop ff the ewaste : Where do othe researchers drop ff the ewaste and where does it end up?
Calculate linear momentum of football player : Use the following scenario for questions 8-10. The mass of Football Player A is 117 kg, and his linear velocity is 6.12 m/s. Calculate linear momentum of Football Player A
Calculate temp increase which would induce max compression : Calculate the temperature increase which would induce maximum compression in the wall of the vessel equal to the maximum tension. young's modulus for steel can be taken as 200Gpa and the coefficient of thermal expansion as 12*10^-6mm(mm Celsius).
Create a pivottable on a new worksheet using the data : Use the data on the Christensen worksheet in the range A1:J19 to create a PivotChart on a new sheet. Use the Type, Issue Price, and Est. Value fields and the default locations. Find the average issue price and average estimated value.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine how far upstream of the section would be expected

The slope of the channel So=.15% and the Manning n=.038. Estimate the depth y2=100m upstream of a section where the flow depth y1=2.2m Using a) the direct integration method and b) the standard step method.

  Determine what will be the cost of labor in dollars

Labor of this activity is given as in the CREW, 1 brick mason and 1 helper. The productivity is 0.5 labor hours per 1 sf. The wages are for the mason $60 and for the helper $45 per hour.

  Determine depth that will result upstream during flood event

A 1.5 m diameter culver (concrete barrel, well - rounded entrance) that is 20m long is installed on a slope of 2 percent. The design discharge is 9.5 m^3/sec and the inlet will be submerged but not the outlet.

  Determine the forces applied at a and b

Knowing that these forces are equivalent to a force-couple system at C consisting of the force C= (- 8 N)i+ (4 N)k and the couple Mc =(360 N ⋅ m)i, determine the forces applied at A and B when Az = 2 N.

  How many moles of aluminum

How many moles of aluminum do 5.2×1024 aluminum atoms represent?

  Determine what is the resulting solids concentration

Raw primary sludge at a solids concentration of 4% is mixed with waste activated sludge at a solids concentration of 0.5%. The flows are 20 and 24 gal/min, respectively. What is the resulting solids concentration

  Determine if the bridge would fail under a given load

Determine if the bridge would fail under a given load. The truck has two axles and the graph should should begin with 1 axle 7 ft into bridge with the other just reaching the bridge.

  Plot the resulting concentration with downstream distance x

Write the mass balance equation for an ideal 1D plug-flow stream under steady state conditions with a first-order decaying substance. Solve for the concentration as a function of the concentration x=0, the rate constant kd, longitudinal distance x..

  Determine the difference in piezometric prcssure

A manometer is used to measure the pressure difference between points A and B in a pipe. Water flows in the pipe, and the specific gravity of the manometer fluid is 2.8. The distances and manometer deflection are indicated.

  Calculate carbonate-noncarbonate and total hardness

Calculate carbonate, noncarbonate, and total hardness Na+ = 27.8 mg/L Cl- = 35.6 mg/L Ca+2 = 48mg/L CO3-2 = 30 mg/L Mg+2 = 12mg/L HCO3- = 61 mg/L K+ = 12 mg/L SO4-2 = 48 mg/L

  Determine what is the probability that the system operates

Consider a system that consists of 4 devices. The probabilities of failure for each of the devices are, respectively: 10%, 25%, 20%, and 30%. (a) If these components were in series, what is the probability that the system operates

  Determine selling price that yields effective annual return

Five $1,000 bonds having a bond rate of 8% per year payable quarterly are pur chased for $4,940 and kept for 6 years, at which time they are sold. Determine the selling price that yields a 6% effective annual return on the investment.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd