### Application of gis in transportation engineering

Assignment Help Other Engineering
##### Reference no: EM132012664 , Length: 6000 Words

Dissertaion

Topic : Application of GIS in transportation engineering

Words: 6000

### Write a Review

#### What is the quiescent current

A class AB output stage using a two-diode bias network as shown in Fig. 12.14 utilizes diodes having the same junction area as the output transistors. For VCC =10 V, IBIAS = 1 mA, RL =100Ω, Βn =50, and /VCEsat / =0 V, what is the quiescent curren..

#### Write and compile a program to toggle all the bits of porta

Test the operation of the ports of your Development board as follows. Write and compile a program to toggle all the bits of PORTA, and PORTB continuously by sending 55H and AAH to these ports.

#### What is the limit on power that can be transmitted on line

What is the limit on power that can be transmitted on the line? What is the energy content of pulses propagating on the two infinitely long lines?

#### Determine the net force and the net moment

Determine the net force and the net moment on the rectangular gate shown below. The hinge is at the top and the salt water has a density of 1.99 slug/ft3.

#### Determine the magnitude of resulting forces

Knowing that the drill exerts a 12 N m · couple on the piece of plywood, determine the magnitude of the resulting forces applied to the nails if the are located

#### Find the inductive reactance per mile

Find the inductive reactance per mile of a single-phase overhead transmission line operating at 60 Hz, given the conductors to be Partridge and the spacing between centers to be 20 ft.

#### Magnitude of the force

A chain of length l and mass m lies in a pile on the floor. If its end A is raised vertically at a constant speed v, express in terms of the length y of chain which is off the floor at any given instant

#### Environmental policy literature review implications topic

topic quothow is the problem of ghg emissions represented in victorian transport policyquot ltbrgt ltbrgtwords2000

#### Identify arp structure and its fields in a pox controller

MN622 - Identify the ARP structure and its fields in a POX controller and Configure the POX controller that replies ARP requests

#### Explain the basic operation of an n-channel jfet

Explain the basic operation of an n-channel JFET. Explain the regions of operations in a JFET. How do you compare the Pinch-off voltage and Cutoff Voltage.

#### What are the generator and load resistances

A long transmission line has a 50 O impedance, with a 2 Volt DC source on one end and a resistor load. What are the generator and load resistances (RG and RL)

#### Input-output relationship of a discrete lti system

Calculate the impulse response h[n] of the system and verify the output with matlab program - Is this a causal and stable system> Explain.