A timber beam 6 in wide by 12 in deep is loaded and

Assignment Help Civil Engineering
Reference no: EM13383467

A timber beam 6 in. wide by 12 in. deep is loaded and supported as shown below. The modulus of elasticity of the timber is 1200 ksi. A pointer is attached to the right end of the beam. Determine the deflection of the right end of the pointer and the maximum deflection of the beam. 

Reference no: EM13383467

Questions Cloud

An aluminium wire and a steel wire each of length 20m are : an aluminium wire and a steel wire each of length 2.0m are hung from the ceiling. a 5.0kg mass is suspended from the
If the heat capacity of the calorimeter and its contents is : a 10g sample of acetic acid hc2h3o2. was burned in a bomb calorimeter in an excess of oxygen. the temperature of the
A simple curve has a central angle of 42degreess a point y : a simple curve has a central angle of 42degreess. a point y is located 24m from the vertex and has a perpendicular
Choose the reaction type that is most likely to occur if : choose the reaction type that is most likely to occur if the two chemical species given in each question are mixed.
A timber beam 6 in wide by 12 in deep is loaded and : a timber beam 6 in. wide by 12 in. deep is loaded and supported as shown below. the modulus ofnbspelasticity of the
At 80 degc the vapor pressures of pure liquids x y and z : at 80 degc the vapor pressures of pure liquids x y and z are 385 190 and 66 mm hg respectively. what pressure must be
If the concentration of no2 is 55 times 105 ppm and the : a 100.0-l flask contains a mixture of no2 gas and co gas. if the concentration of no2 is 5.5 times 105 ppm and the
It contains 578 percent c 364 percent h and 385 percent o : terephthalic acid is an organic compound used in the formation of polyesters. it contains 57.8 percent c 3.64 percent h
You are working as a project analyst for the local gas : you are working as a project analyst for the local gas utility and you have been placed on a project to install an

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the velocity of slider block c

Determine the velocity of slider block C at t=0, (b) the acceleration of A and C, (c) the change in position of block A after 5s.

  Hydraulic radius of the river

In that season, what are the hydraulic radius of the river, its mean velocity and volumetric discharge?

  Find flow rate in pipe whose water surface elevations differ

A 110 f t long, 5 in in diameter (f = 0:033) connects two reservoir whose water surface elevations differ by 12 f t. Compute flow rate in pipe.

  What is the maximum value of fz possible with no increase

The flowrate in a rectangular channel is 20 m3/s. The width of the channel is 4 m and the depth of flow is 5 m. If there is an increase in the channel bottom elevation with NO energy loss,

  Find what design speed was used for freeway exit ramp

A freeway exit ramp has a single 12-foot lane and consists entirely of a curve with a central angle of 90 degrees and L=628 feet. If the distance cleared of obstacles is 19.4 feet from the centerline, what design speed was used

  Elevation of the curve turning point

Set up a table showing curve elevations at the PVC, at the PVT, and at the half-station points along the curve. Compute the station and elevation of the curve turning point.

  Which pipe would be suggested to the axis chemical company

Axis Chemical Company needs you to design a gravity sewer to convey 1,750 GPM of toxic waste. The pipe is to be glass-lined reinforced concrete (n = 0.009). Which pipe would you suggest the Joker use

  Determine what is the partial pressure of the dry air

If the barometer reads 102 kPa abs, what is the partial pressure of the dry air, and what is its specific weight. What is the specific weight of the atmosphere (air plus the water vapor present).

  Determine will a booster pump be required for the building

The water pressure in the municipal pipeline is 450 kPa, the sum of the local loss coefficients in the building pipes is 11.0, and the flow to be delivered to the top floor at 25 L/s through a 150-mm diameter PVC pipe.

  Find what concentration would correspond to a risk

The drinking water standard for tetrachloroethylene is 0.005 mg/L. Using EPA exposure factors for residential consumption, what lifetime risk would this pose What concentration would correspond to a risk of 10-6

  What biodegradation reaction rate coefficient be achieved

Assuming the lagoons are well mixed and that there are no losses or gains of water in the lagoon other than the sewage input, what biodegradation reaction rate coefficient (in day^-1) must be achieved for a first order reaction that governs the de..

  The behaviour of structural materials using comparative

the behaviour of structural materials using comparative statement when they are formed into structural

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd