A rigid tank of cold fluid sits in a room at 300 k t the

Assignment Help Mechanical Engineering
Reference no: EM13628772

A rigid tank of cold fluid sits in a room at (300 K = T..). The fluid is initially at (180 K = T.). THe luis temperature is observed to vary with time as: Tfluid(t) = T..-(T..-T.)exp[-t/time constant(3600s). The energy absorbed by the tank wall is negligible. Assume the tank wall thickness is constant and that the tank inner surface temperature is the same as the fluid temperature. Plot Ffluid(t), Tsurface(t) and Q(t). Given: Tank surface area = 2.2 m^2, wall thickness =.11m, wall thermal conductivity = .0014 kW/m-K, and the surface convection coefficient = .0005 kW/m^2-K.

a) Find the fluid Tfluid and outer surface Tsurface and the heat transfer rate versus time for t= 30 minutes and t = 3 hours.

b) Determine the total amount of heat transferred over the period of 0-->3 hours, Q (kJ)

Reference no: EM13628772

Questions Cloud

A current of 1820 ma is maintained in a single circular : a current of 18.20 ma is maintained in a single circular loop with a circumference of 3.31m. a magnetic field of
The resistance of a very fine tungsten wire with a 10 : the resistance of a very fine tungsten wire with a 10 micro m x 10micro m square cross section is 2978 ohm how long is
Mos technology is used to fabricate a capacitor utilizing : mos technology is used to fabricate a capacitor utilizing the gate metallization and the substrate as the capacitor
Suppose that the number of accidents at a nuclear power : suppose that the number of accidents at a nuclear power plant in one week has a poisson distribution with mean 3 and
A rigid tank of cold fluid sits in a room at 300 k t the : a rigid tank of cold fluid sits in a room at 300 k t... the fluid is initially at 180 k t.. the luis temperature is
The resistance of a very fine tungsten wire with a 10 : the resistance of a very fine tungsten wire with a 10 micro m x 10micro m square cross section is 2978 ohm how long is
The hot dog cooker described in the chapter heats hot dog : the hot dog cooker described in the chapter heats hot dog by connecting them to 91 v house hold electricity. a typical
Two draws will be made at random from a box containing 5 : 1. two draws will be made at random from a box containing 5 marbles red yellow green black and blue. the unconditional
Assume that the change in kinetic energy is negligible : liquid waterh2o at 200 kpa and 20oc is heated in a chmaber by mixing it with a steam h20 at 200 kpa and 150oc. the

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  A four cylinder four stroke gasoline internal combustion

a four cylinder four stroke gasoline internal combustion engine has a bore of 9.4 cm and a stroke of 8.6 cm. the

  Calculate the speed at which the ball leaves the spring

A small steel ball bearing with a mass of 13 g is on a short compressed spring. When aimed vertically and suddenly released, the spring sends the bearing to a height of 1.35 m. Calculate the speed at which the ball leaves the spring.

  Determine a the average force at the wheels of the cab b

a trailer truck enters a 2 percent uphill grade traveling at 72 kmh and reaches a speed of 108 kmh in 300 m. the cab

  What is the actual strain

You have a 120 Ω quarter bridge 2 wire set up with Sg=2.10 and an unknown lead wire resistance. A 59880Ω calibration resistor is switched in parallel to the gage only and a recording instrument is set to give a -100 mm deflection for this calibrat..

  Determine the total length of the 12 tube that is required

a heater is required to supply the domestic hot water dhw in a 50 unit apartment building where the dhw load is

  An fcc iron-carbon alloy initially containing 020 wt c is

an fcc iron-carbon alloy initially containing 0.20 wt c is carburized at an elevated temperature and in an atmosphere

  An electron is shot vertically straight up from the ground

in a particular location the horizontal component of the earths magnetic field has a magnitude of 2.00 10-5 t. an

  Saturated liquid exits the condenser and there is a 20 deg

the vapor-compression refrigeration system uses r-134a as its working substance. the pressure upstream and downstream

  Calculate the normal stress in each rod

In our stress calculation example, we had an array of rod diameters and wanted to calculate the normal stress in each rod when it is loaded by an axial load P of 1000 lbs. EDU stresscalc ?

  What is discharge revised discharge pressure of compressor

What is the discharge revised discharge pressure (guage pressure) of the compressor ?  Is the assumption of change in temperature valid for calculating the discharge pressure of the compressor ?

  Find the rate of change of the density in the tire

Air at 250 kPA and 15C is being forced into a tire, which has a volume of 0.5m^3, at a velocity of 60 m/s through a 6 mm opening. Find the rate of change of the density in the tire.

  Consider a 15-cell stack hydrogen fuel cell operating

consider a 15-cell stack hydrogen fuel cell operating steadily in series with 200 cm2 active area per electrode with a

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd