Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A drinking water treatment plant will be designed to process a flow of 15,000 m3/d. The sedimentation tank will have a residence (detention) time of 4 hours and the overflow rate (Q/A) of 16 m3/m2-day. Estimate the required surface area (A), and the diameter and the depth of the tank.
An investor is considering buying a 20-year corporate bond. The bond has a face value of $1000 and pay 6% interest per year in two semiannual payments. To receive 8% interest, compounded semiannually, how much should be paid for the bond
Maintenance expenses for a bridge in west Tennessee are estimated to be $200,000 for the first eight years followed by two separate million dollar expenditures in years 12 and 18. The expected life of the bridge is thirty years.
Ends A and D of the two solid steel shafts AB and CD are fixed, while ends B and C are connected to gears. Knowing that a 4-kN(m) torque T is applied to gear B, determine the maximum shearing stress (a) in shaft AB, (b) in shaft CD.
An electrodialysis is used to treat a stream of 125 m3/d produced water with a salinity of 13,000 mg/L NaCl before the produced water is discharged to the river with the flow rate of 5 million L/d and salinity of 20 mg/L NaCl.
Water flows through a tube at a rate of 7.5 kg/min while heat is added to it at a rate of 4.5 kW. If water entered at 20 degrees celcius, determine the exit temperature. Assume the pressure remains constant at 1 atm throughout.
An engineer has to design a rod made with the same steel to carry a load of 150 kips without yielding. He desires to have a factor of safety against yielding of 1.5. What should be the cross-sectional area of the circular rod
Two hemispheric shells are perfectly sealed together, and the internal pressure is reduced to 43 % of atmospheric pressure. The inner radius is 10.5 cm, and the outer radius is 10.75 cm. The seal is located halfway between the inner and outer radi..
A permanent endowment at the University of Alabama is to award scholarships to engineering students. The awards are to be made beginning 5 years after the $10 million lump-sum donation is made.
The owners wish to achieve an initial acceleration from rest of 22 ft/(sec^2) on a level paved surface. What is the minimum coefficient of road adhesion needed to achieve this acceleration
A steel bar is attached to a wood support beam with four 20 mm diameter lag screws. The steel bar is 75-mm-wide by 6-mm-thick. For the steel bar, the yield strength is 260 MPa and the ultimate bearing strength is 350 MPa.
What is the design storage and water surface elevation at the peak outflow rate and estimate the long-term average reduction (EPA, 1986) in particulates under dynamic conditions.
Draw a P-V diagram for pure component and label appropriate points such as superheated region, isothermal line, etc.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd