100kpa and 22 degc air is contained in a rigid tank of 2 m3

Assignment Help Mechanical Engineering
Reference no: EM13630871

100kPa and 22 °C air is contained in a rigid tank of 2 m3. There is supply line connected to the tank through a valve. If the valve opens, the air in the supply line with 600kPa and 22 °C flows into the tank. Valve is shut off when the tank air pressure reaches to 600kPa and the final tank air temperature is 77 °C.

Determine:1) amount of the air entered the tank in kg; 2) amount of the heat transfer in kJ

Reference no: EM13630871

Previous Q& A

  A square plate of edge length 120 cm and negligible

a square plate of edge length 12.0 cm and negligible thickness has a total charge of 5.80 x 10-6 c. estimate the

  More heat is transferred to the air until the temperature

five kilograms of air at 300 k is contained in a vertical cylinder by a frictionless piston of a mass such that the

  A mixing chamber steadily mixes a hot water stream at

a mixing chamber steadily mixes a hot water stream at 80degc and 0.5kgs rate with a cold water stream at 20degc. if the

  A nozzle with inlet area of 800 cm2 and inlet steam

a nozzle with inlet area of 800 cm2 and inlet steam velocity is 10ms. the steam pressure is 800kpa and temperature is

  Using the classical and relativistic expressions for

using the classical and relativistic expressions for kinetic energy calculate the range of velocities for a particle of

  Knowing that the constant of eachspring is 2 knm determine

a 10-kg block is attached to spring a and connected to spring b bycord and pulley. the block is held in the position

  A heat pump with a cop of 30 is used to heat air contained

a heat pump with a cop of 3.0 is used to heat air contained in a 1205.4m3 of well-insulated rigid tank. initially the

  It is now cooled at constant volume to 200 deg c this

a system with an initial volume of 2 m is filled with water at 3 mpa 400 deg c.it is now cooled at constant volume to

  A system executes a power cycle while receiving 1050 kj by

a system executes a power cycle while receiving 1050 kj by heat transfer at a temperature of 525 k and discharging 700

  Determine the total mass of water remaining in the tank and

a 0.06m 3 rigid tank initially contains water at 1.5 mpa with a quality of 20. the tank is heated and a pressure

Reviews

Write a Review

 

Similar Q& A

  Determine the work and the heat transfereach in btu using

air is compressed in a piston-cylinder assembly from p1 10lbfin.2 t1 500or to a final volume of v2 1 ft3 in a process

  Find densities, enthalpies and efficiency for gas

find densities, enthalpies and efficiency for gas turbine power cycle with the following conditions.

  Discuss the sequence of actions that occur in the operation

discuss the sequence of actions that occur in the operation of the control system for a traffic light that includes

  The time required for the operator to retrive an item after

carousle conveyors are used for storage and order picking for small parts.the conveyors rotate clockwise or counter

  Consider a mass going through a polytropic process where

consider a mass going through a polytropic process where pressure is directly proportional to volume n-1 the process

  Saturated vapor steam at 5 psia eneters an adiabatic heat

saturated vapor steam at 5 psia eneters an adiabatic heat exchanger and leaves as saturated liquid at 5 psia. the steam

  Heat is conducted along a circuit board that has a copper

heat is conducted along a circuit board that has a copper layer on one side. the circuit board is 15 cm long and 15 cm

  Assignment 1 product and engineering design reviewmust

assignment 1 product and engineering design reviewmust contain a brief description of the product then delve into

  Moist air at standard conditions in an indoor building

moist air at standard conditions in an indoor building space has a dry bulb temperature of 72f and relative humidity

  Determine the final velocity

Determine the Final Velocity, An object whose mass is 1 lb has a velocity of 100 ft/s. How would I determine the final velocity, in ft/s, if the kinetic energy of the object decreases

  Find the following a the final volume and the mass of the

one end of a tube is closed and the other is open. a 15 g projectile is placed near the closed end is fastened in place

  By what percent would the plane have been under-fueled for

calculate various fuel quantities for flight 143. the plane already had 7682 l of fuel on board prior to the flight and

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd