What is button, Electrical Engineering

A button does some command in a program when it is clicked. Buttons generally have a 3-dimensional look, although you may have to move the mouse over the button for it to look 3D. You should one-click on buttons (do not double-click).   

 

 

Posted Date: 4/5/2013 5:52:14 AM | Location : United States







Related Discussions:- What is button, Assignment Help, Ask Question on What is button, Get Answer, Expert's Help, What is button Discussions

Write discussion on What is button
Your posts are moderated
Related Questions
Why is the signal first attenuated and then amplified?

Q. What do you mean by Most and least significant digits? The MSD (most significant digit) in a number is the digit which represents the largest part of the number. Therefore i

Call Instructions Call instruction are used to call a  subroutine program in assembly language  procedure and functions are called  subroutines. There are two types  of calls i

Q. In the circuit shown in Figure, use the ideal op-amp technique to find: (a) v o as a function of v i . (b) The voltage at A.

Ask question introduction of co2 single stroke positive displacement pump using cam and follow system to transfer co2 into small cylinders

The Octal Butters 74LS244 It has  two group  of four  buffer with  no inverted tri state  output ,  controlled by  two active  low  enable lines  (1G and 2G)  as shown in figur

Q. Which are the different FET amplifiers? A FET can be used as a small-signal amplifier by connecting one of its lead to signal ground. The other two leads then serve as the i

Q. Can you explain about Trapeziodal Clippers? During The Positive half cycle, the diode D1 will be open circuited and the input appears as the output until, the applied bias v

PLC ( Programmable Logical  Controller ) PLC  stand for programmable logical  controller.  PLC   is an  industrial computer  used to monitor inputs and depending upon  their  m